Sharp PG-C30XA, Руководство по эксплуатации

Страница: 12 / 64

11
Setup & Connections
Connecting the Power Cord
Plug the supplied power cord into the AC socket on the back of the projector.
Connecting the Projector to a Computer
You can connect your projector to a computer for projection of full colour computer images.
To a computer using the standard 15-pin input
1
Connect one end of the supplied computer RGB cable
to the INPUT 1 or 2 port on the projector.
2
Connect the other end to the Monitor output port on the
computer. Secure the connectors by tightening the
thumb screws.
3
To use the built-in audio system, connect one end of
the supplied computer audio cable to the AUDIO INPUT
terminal for INPUT 1, 2 on the projector.
4
Connect the other end to the Audio output terminal on
the computer.
CAUTION
• Before connecting, be sure to turn both the projector and the
computer off. After making all connections, turn the projector
on first. The computer should always be turned on last.
• Please read the computer’s operation manual carefully.
• Refer to page 54 “Computer Compatibility Chart” for a list of
computer signals compatible with the projector. Use with
computer signals other than those listed may cause some of
the functions not to work.
When connecting this projector to a computer, select
“Computer/RGB” for “Signal Type” on the GUI menu. (See
page 27.)
• A Macintosh adaptor may be required for use with some
Macintosh computers. Contact your nearest Authorised Sharp
Industrial LCD Products Dealer or Service Centre.
Connecting the Projector
Power cord
Computer RGB cable
Computer audio cable