2
For your safety
This installation manual and the Mini OPS product use
various displays and labels to ensure safe use. Ignoring
these displays and labels and incorrectly using the product
could have results as listed below.
Please read the following warning symbol information
before reading the rest of this section, and be sure to
strictly observe all instructions.
Warning:
Not following these instructions
could result in death or serious
injury.
• Be sure to turn off the main power switch of the
monitor and disconnect the power before attaching/
detaching this product.
Otherwise, you may suffer electric shock.
• Only use the accessories with specifi ed models.
Otherwise, fi re may result.
• Do not make any modifi cations to this product.
Otherwise, fi re may result.
Installation procedure
Caution
• This product must be Installed and removed by your
dealers or service engineers.
• Do not touch the circuit board or the connectors
of this product or the connectors of the LCD
MONITOR. The static electricity in your body may
cause a malfunction.
• Touch a grounded source to discharge the static
electricity in your body before starting operation.
• The illustrations in this manual are for explanatory purposes
and may not exactly represent the actual product.
1. Set the main power switch of the monitor to
“off” and disconnect the power from the wall
outlet.
2. Spread a thick and soft cloth (such as a blanket)
on a level surface, such as a table, and place the
monitor on it with its LCD panel facing downward.
3. Remove the mini OPS expansion slot cover.
Remove the 2 screws.
For the location of the mini OPS expansion slot,
refer to the operation manual of the LCD MONITOR.
Give the mini OPS expansion slot cover to the customer
and ask them to store it.
Always install the mini OPS expansion slot cover after
removing the mini OPS expansion board.
4. Hold the mini OPS expansion board by the handles, and
push it all the way into the mini OPS expansion slot.
5. Verify that the mini OPS expansion board has been
installed.
Make sure that the alignment protrusion is
properly inserted into the hole.
6. Use the 2 screws removed in step 3 to fix the mini
OPS expansion board in place.
7. Affix the terminal label in the designated label
position.
■
Removing the mini OPS expansion board
Remove the 2 screws, grasp the handles, and then pull
out the mini OPS expansion board.
Procédure d’installation
