Sharp LC-32LE511E, Руководство по обслуживанию

Страница: 16 / 156

16
LC-32LE511
LC-40LE511
LC-40LE531
Operation Manual (Continued)
English - 16 -
Remote Control Handset
Remove the battery cover located on the back of •
the remote control by gently pulling backwards from
the indicated part.
Insert two
• AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control when
it is not to be used for a long period. Otherwise it can
be damaged due to any leakage of batteries.
Switching the TV On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC 50 Hz.
Switch the “ • ” button on the rear left hand side
to position “|” so the TV will switch to standby mode.
Then the standby LED lights up.
To switch on the TV from standby mode either:
•
Press the “ • ” button, P+ / P- or a numeric button
on the remote control.
Press the “
• ” or +/- button on the TV.
The TV will then switch on. •
Note : If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
To Switch the TV to Standby
To switch the TV to low power standby press the
“ ” button on the remote control or right hand side
of the TV.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
To Switch the TV Off
Switch the “ • ” button bottom right edge under the
screen to position 2 as illustrated, to isolate the
TV from the mains, the LED will go out.
If the TV will not be used for a long period i.e.
•
holidays, then unplug the power cord from the
mains socket.
Digital Teletext (** for UK only)
Press the “ • ” button.
The digital teletext information appears. •
Operate it with the coloured buttons, cursor buttons •
and OK button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on digital teletext
screen.
When Press “ • SELECT ” button or similar message
appears on the screen, press the OK button.
When the “
• ” button is pressed, the TV returns to
television broadcasting.
With digital terrestrial broadcasting (DVB-T), in
•
addition to digital teletext broadcasting together with
the normal broadcasting, there are also channels
with just digital teletext broadcasting.
The aspect ratio (picture shape) when watching
•
a channel with just digital teletext broadcasting is
the same as the aspect ratio of the picture viewed
previously.
When you press the “
• ” button again, the digital
teletext screen will be displayed.
[GB]_MB70_1910UK_IDTV_T2_32942LED_STORE_MODE_GOLD11_10072643_50186875.indd 16 06.07.2011 15:28:51