2. REMOVAL OF DVD DECK PARTS
NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y/LOADING MOTOR PCB ASS'Y/
PLATE TRVS UD (Refer to Fig. 2-1-A)
1. Remove the screw (1).
2. Remove the screw (2).
2.2: HOLDER TRAVERSE/INSULATOR (F)/
3. Unlock the 5 supports (3).
INSULATOR (R)/FEED RACK ASS'Y/
4. Remove the Insulator (R) from the Loader Ass'y.
PCB630/GEAR MIDDLE/GEAR FEED/
5. Remove the Traverse Ass'y and Plate Trvs Ud.
FEED MOTOR/GEAR MOTOR
(Refer to Fig. 2-2-A)
1. Remove the Holder Traverse.
2. Remove the Insulator (F).
3. Remove the Insulator (R).
4. Remove the screw (1).
5. Remove the Feed Rack Ass'y.
6. Remove the screw (2).
7. Remove the PCB630.
DISASSEMBLY INSTRUCTIONS
Traverse Ass'y
Insulator (R)
(1)
(2)
Plate TRVS UD
Fig. 2-1-C
Check Lock
B2-1
7. Remove the PCB630.
8. Unlock the support (3).
9. Remove the Gear Middle.
10. Remove the screw (4).
11. Remove the Gear Feed.
12. Remove the 2 screws (5).
13. Remove the Feed Motor.
14. Remove the Gear Motor.
• Screw Torque: 1.0 ± 0.3kgf•cm (screw(1))
• Screw Torque: 3.0 ± 0.3kgf•cm (screw(2))
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw (2))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (4), (5))
Loader Ass'y (Top side)
Loader Sub Ass'y
(3)
(3)
(3)
Fig. 2-1-A
Fig. 2-1-B
Check Lock
Check Lock
Check Lock
(3)
Traverse Ass'y
Feed Motor
Gear Middle
(5)
(5)
(4)
Gear Feed
(3)
(1)
PCB 630
(2)
Feed Rack Ass'y
Gear Motor
Fig. 2-2-A
Insulator (F)
Insulator (F)
Holder Traverse
Insulator (R)
B2-1
