Sharp KI-A60E, Руководство по эксплуатации

Страница: 21 / 76

E-19
EN
GL
ISH
Filter Frame (gray)
SYMPTOM REMEDY (the following are not due to a malfunction)
Odour and smoke persists.
• Check the filters. If they appear to be extremely dirty, clean or
replace them.
(Ref. E-12,E-18)
The Front Monitor light is green
even when the air is not clean.
• The air may have been dirty when the unit was plugged in.
Unplug the unit, wait one minute, and then plug the unit in again.
The Front Monitor light is
orange or red even when the air
is clean.
• Dirty or clogged dust sensor openings interfere with sensor
operation. Gently clean the back panel. (Ref. E-14).
The unit makes a clicking or
ticking sound.
• The unit may make clicking or ticking sounds when it is
generating ions.
Air discharged from the unit has
an odour.
• Check to see if the filters are extremely dirty.
• Clean or replace the filters.
• Plasmacluster Air Purifiers emit small traces of ozone that can
produce an odour.
The unit does not operate when
cigarette smoke is in the air.
• Check to see if the unit is installed in a location that makes it
difficult for the sensors to detect cigarette smoke.
• Check to see if the dust sensor openings are blocked or clogged.
If they are blocked or clogged, clean the back panel. (Ref. E-14)
The Filter Indicator Light is on.
• Whenever replacing the filters, connect the power cord to an
outlet and then press the Filter Reset Button. (Ref. E-12)
The Front Monitor lights are
turned off.
• Check to see if the Lights OFF Mode is selected. If it is selected,
press the Lights Control Button to turn the indicator lights on.
(Ref. E-10)
The Water Supply Indicator
Light does not light up when the
tank is empty.
• Check the styrofoam float for impurities. Clean the Humidifying
Tray. Make sure that the unit is on a level surface.
The water level in the tank does
not decrease or decreases
slowly.
• Check to see if the Humidifying Tray and Water Tank are
correctly installed. Check the Humidifying Filter.
• If the filter is extremely dirty, clean or replace it.
(Ref. E-13, E-18).
The Front Monitor lights change
colour frequently.
• The Front Monitor lights automatically change color when the
dust sensor and odour sensor detect impurities.
There is a discrepancy between
the unit’s Humidity Monitor
and another hygrometer in the
room.
• There is a difference in the humidity level within the same room.
• The sensor have different measurement parameters.
• If the monitor indicates WATTAGE, press the DISPLAY button.
(Ref. E-11)
Before calling for service, review the troubleshooting chart below to make sure that the problem is not
a unit malfunction..
TROUBLESHOOTING
OM_KI-A60E_EN.indd 19 12.3.1 10:55:10 AM