Sharp K-60M15BL2-EU, Руководство пользователя, Страница: 115 / 124

EN - 10
– In case of any damage to the supply
cable, make sure to call your author-
ised service supplier. The cable must
be replaced by your authorised ser-
vice supplier.
– Wiring of the appliance must be per-
formed by your authorised service
supplier. H05VV-F type supply cable
must be used.
– Faulty wiring may damage the appli-
ance. This type of damage will not be
covered under the warranty.
– The appliance is designed to connect
to 220-240V – if your electricity is dif-
ferent than the value given above,
call your authorised service supplier
immediately.
– The manufacturer declares that it
bears no responsibility whatsoev-
er for any kind of damage and loss
arising from non-compliance with
safety norms!
If the oven is installed under a hob, the
distance between the worktop and the
top panel of the oven must be minimum
50 mm and the distance between the
worktop and the top of control panel
must be minimum 25 mm.
WIRING AND SAFETY OF BUILT-
IN OVEN
The instructions given below must be
followed without fail during wiring:
– Screw the earthing cable at the earth-
ing mark. Supply cable connection
must be as shown in Figure 6. If there
is no earthed outlet conforming to
regulations in the installation envi-
ronment, call your authorized service
supplier immediately.
– The earthed outlet must be close to
the appliance. Never use an exten-
sion cord.
– The supply cable should not contact
the product’s hot surface.