Sharp HT-SB40, Руководство по эксплуатации

Страница: 16 / 16

9
1
7
6
5
4
3
2
1
9
2012 December 21
HT-SB40
E-15
Periodically wipe the cabinet with a soft cloth.
Caution:
●
Do not use chemicals for cleaning (gasoline, paint
thinner, etc.). It may damage the cabinet finish.
●
Do not apply oil to the inside of each component. It may
cause malfunctions.
When you fail to perform operations properly, the following
messages are displayed on the sound bar.
(*): Should the same message appear even if the speaker is
unplugged and plugged in, or is set to the stand-by mode
and on again, contact your local dealer where you
purchased the sound bar.
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification changes
for product improvement without prior notice. The
performance specification figures indicated are nominal
values of production unit. There maybe some deviations
from these values in individual unit.
Display Meanin g
(Display blinks)
●
When there is no input signal.
Play back the connected
equipment.
●
Nonstandard signal. Cannot
be recognized.
●
Signals other than DOLBY
DIGITAL, DTS, Linear PCM
cannot be recognized.
●
Poor connection of the digital
audio input terminal.
●
Turn off the sound bar and
check if the cable is
connected properly.
Demo indicator
(blinks red)
●
When the protection circuit is
activated.
Maintenance
Cleanin g the cabinet
Error indicators and warnin g s
Power source AC 120 V ~ 60 Hz
Power
consumption 38 W
Dimension Width: 37 - 1/16" (940 mm)
Height: 2 - 7/8" (73 mm)
Depth: 3 - 1/4" (83 mm)
Wei g ht 7.27 lbs. (3.3 kg)
Output power RMS: Total 160 watts
RMS:
Front Left/Right:
80 watts per channel into 4 ohms at
1 kHz, 10% total harmonic distortion
FTC:
Front: (Left/Right):
Minimum 50 watts per channel into
4 ohms at 120 Hz to 20 kHz, 1% total
harmonic distortion
Output
terminal HDMI™ output: (audio/video support up
to 1080p) x 1
Input terminal Analog input (AUDIO IN): x 1
500 mV / 47 kohms
Optical digital input (OPTICAL):
Square type x 1
HDMI input: (audio/video support up to
1080p) x 2
Type 2 Way speaker system
2 -1/4" (5.7 cm) woofer
1" (2.5 cm) Soft Dome
Maximum
input power 160 W
Rated input
power 80 W
Impedance 4 ohms
Power source AC 120 V ~ 60 Hz
Power
consumption 33 W
Output power RMS:
150 watts per channel into 3 ohms at
100 Hz, 10% total harmonic distortion
FTC:
Minimum 110 watts per channel into
3 ohms at 100 Hz, 1% total harmonic
distortion
Type Subwoofer system
6 - 5/16" (16 cm) woofer
Maximum
input power 300 W
Rated input
power 150 W
Impedance 3 ohms
Dimensions Width: 5 - 11/16" (144 mm)
Height: 16 - 15/16" (430 mm)
Depth: 12 - 1/16" (306 mm)
Wei g ht 13.42 lbs. (6.1 kg)
Specifications
Sound Bar
Subwoofer