Sharp FU-E30A-W, Руководство по эксплуатации

Страница: 9 / 20

E - 16 E - 17
TROUBLESHOOTING
Double check before
you send the product
for repair.
Problem Solution
●
Is the filter still wrapped in the plastic bag?
Take out the filter from the plastic bag.
●
Is the wind blowing become weaker?
Clean the areas with
★
in the following table:
●
Is the unit used in a room with strong smells?
If the unit is used in the presence of strong smells such as
cigarette and roast, the filter may smell .
It is recommended to frequently ventilate the room where
the air purifier is used.
●
Clean the areas with ★ in the following table, if odor
persists, replace the filter.
●
The Plasmacluster Ion generator could generate a tiny
amount of ozone together with Plasmacluster Ions.
Therefore, odor may come out from the air outlet, which
does not affect your health.
●
Clean the areas with
★
in the following table:
●
After maintenance, press and hold the FILTER RESET
button for 3 seconds or longer.
●
The sound is heard when Plasmacluster Ions are
generated. The sound volume varies with the working
environment and operation mode. Sometimes, the sound
cannot be heard but the effect of Plasmacluster Ions is
completely the same.
Odor comes out from
the air outlet.
The FILTER RESET
indicator light is lit.
The FILTER RESET
indicator light does
not turn off.
A continuous clatter is
heard.
The odor or smoke is
hard to remove.
-
-
-
Problem Solution
●
When start the operation, the sensor may become unstable
in sensitivity and the color of the odor sensor may not
change.
After the unit has been running for several minutes, the
sensor sensitivity will become stable.
●
If the indicator light of sensor turns green and persists, the
air is clean. It may be difficult to sense odor. When you blow
cigarette smoke to the sensor or slap a towel near it, if the
colors of the odor sensor and dust sensor have changed,
this means that the sensor is working properly.
●
If you switch the unit on when the room has a strong smell,
the sensitivity of the odor sensor may be deteriorated.
Set Fan Speed to
MED
and run the unit for several hours
or whole day.
●
Sometimes, the sensor sensitivity does not match the room
conditions.
Shut down the unit, and adjust the sensitivity.
The Indicator Light
does not change.
-
-
●
The door or windows are opened frequently. In a room
with poor air tightness, it takes some time to purify the air
(until the sensor turns green).
The Indicator Light
never turns green.
●
The door opened and closed constantly, wind and sharp
temperature changes may cause reactions.
The Indicator Light
switches its state
frequently.
-
-
Reference
Page
Reference
Page
ODOR
Rear Panel Main Unit
★ ★
Cleaning Areas
2-in-1 HEPA &
Deformaldehyde Filter
Rear Panel Main Unit
★
Cleaning Areas
2-in-1 HEPA &
Deformaldehyde Filter
Rear Panel Main Unit
★
Cleaning Areas
2-in-1 HEPA &
Deformaldehyde Filter
INDICATOR LIGHT
SOUND
DUST/ODOR SENSOR
TROUBLESHOOTING
E - 6
E - 12~13
E - 13
E - 12
E - 12
E - 11
E - 11