Sharp FP-H50A, Руководство по эксплуатации

Страница: 12 / 28

E-10
TROUBLESHOOTING
SYMPTOM REMEDY (not a malfunction)
Odors and smoke are not removed.
• Clean or replace the filters if they appear to be heavily soiled.
(Ref. E-8,E-9)
The DUST AND ODOR SIGN
illuminates green even when the air
is impure.
• The air could be impure at the time the unit was plugged in.
Unplug the unit, wait one minute, and plug the unit in again.
The DUST AND ODOR SIGN
illuminates orange or red even
when the air is clean.
• Sensor operation is affected if the odor sensor and dust sensor
filter are dirty or clogged. Gently clean the odor sensor and dust
sensor filter.
(Ref. E-9).
A clicking or ticking sound is heard
from the unit.
• Clicking or ticking sounds may be audible when the unit is
generating ions.
The discharged air has an odor. • Check to see if the filters are heavily soiled.
• Clean or replace the filters.
• Plasmacluster Air Purifiers emit small traces of ozone which may
produce an odor. These ozone emissions are well below safety
level.
The unit does not operate properly
when cigarette smoke is in the air.
• Is the unit installed in a location that is difficult for the sensor to
detect cigarette smoke?
• Is the dust sensor filter blocked or clogged?
(In this case, clean the filter.) (Ref. E-9)
The DUST AND ODOR SIGN is
turned off.
• Check to see if the Lights OFF Mode is selected.
Press
for 3 seconds to turn light ON.
(Ref. E-7)
• Check to see if the SLEEP mode is selected.
The DUST AND ODOR /PLASMACLUSTER SIGN are turned off
automatically after the SLEEP mode is selected.
The DUST AND ODOR SIGN
changes color frequently.
• The DUST AND ODOR SIGN automatically changes colors as
impurities are detected by the dust sensor and odor sensor.
The sensor detection sensitivity can be adjusted lower.
(Ref.E-7)
Before calling for service, please review the Troubleshooting list below, since the problem may not
be a unit malfunction.
OM_FP-H50A.indd 10 2017/04/05 10:01:57