Parts of the washing machine
Machine body
List of accessories
Name
Quantity
Water inlet hose
assembly
1 set
Drain hose
1
Operation manual
Bottom cover
＊
1
1
Screw
＊
1
17
4
Installation manual
1
Top lid
Adjustable foot
Control panel
Water inlet hose
connecting port
Power cable
Pulsator
Lint filter box
Cabinet
Drain hose
Warranty card
1
＊ Bottom cover and Screw are applied by service staff.
Keep the Operation manual and installation manual
for future reference.
Common non-fault phenomenon (Please refer to
this section if there is an abnormality happens.)
Abnormal display
Display
U9
E4
E3
E2
C
＊
Washing machine inclines or is
shaky.
The clothing is lopsided.
The end of drain hose is blocked.
The drain position is
relatively high.
Top lid is not closed during spin
drying.
Possible non-fault cause
Solution
Low flow at the faucet.
Water inlet filter net is blocked.
＊
When water is not supplied enough to
operate the machine, this error code
will be displayed only after six hours.
It generates a beep when washing machine indicates abnormal display.
As the phenomenon may not be a fault,
please check it again before sending the machine for repair. In the case
of failure, please consult Sharp Service Center. Be sure not to disassemble and
repair the machine without permission.
Caution
There is a possibility
of malfunction.
The faucet is closed.
Top lid is opened
when the
reservation
course starts.
Drain hose is folded/crumpled/tied.
Increase water supply, press START/
PAUSE key.
Turn the faucet on, press START/
PAUSE key.
Clean the filter net, press START/
PAUSE key.
Close top lid.
Adjust drain hose properly, press
START/PAUSE key.
Clean drain hose, press START/
PAUSE key.
Level the washing machine by
adjusting the foot.
(
p.18
)
Distribute the clothing evenly.
Turn off the power and pull out Power
cable. After wait 1 minute,
turn on and operate.
Top lid is opened during
CHILD LOCK.
Turn the power off, and check inside
the tub
CHILD LOCK is not released, unless
you reset it manually.
Caution
E1
E
Cannot spin drying.
Adjust drain hose properly.(p.6)
Wait for 10 minutes, and press
START/PAUSE key.
19
NOTE
＊ : number
