Sharp DV-RW260S, Руководство по обслуживанию

Страница: 30 / 116

C4-2
DVD side EEPROM (IC4002) initial setting
Table 2
INIT +0 +1 +2 +3 +4 +5 +6 +7 +8 +9 +A +B +C +D +E +F
3A0 02 01 01 01 02 01 02 01 02 1F 02 01 02 01 02 01
3B0 01 00 02 02 01 02 0E 01 01 00 00 00 00 00 00 00
3C0 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
1.
2.
3. Connect the set to TV Monitor.
Turn on the POWER, and set to the DVD mode.
Press both Channel button (6) on the remote control and the STOP button on the set for more than 2 seconds.
ADDRESS and DATA will appear on TV Monitor as Fig 2 and the ADDRESS is now selected.
3D0 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
INITIAL
000 ERR
3E0 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
3F0 00 00 00 00 00 00 00 00 00 00 00 00 00 07 08 ---
4.
5.
6.
7.
8.
9.
10.
11.
12.
The unit will now have the correct DATA for the new MEMORY IC.
Input the ADDRESS by using C/- button or the following buttons below.
Numbers are 10 keys from 0 to 9, Alphabets are
A: VCR EJECT, B: DVD OPEN/CLOSE, C: DVD/VCR, D: TIMER REC, E: INPUT SELECT, F: DISPLAY.
Press ENTER to select DATA.
Again, step through the DATA using C or - button until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 4 to 7 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
After the data input, set to the initializing of shipping.
Turn on the POWER, and set to the DVD mode.
Press both CH UP button on the set and the PLAY button on the set for more than 2 seconds.
After the finishing of the initializing of shipping, the unit will turn off automatically.
Fig. 2
NOTE:
ADDRESS DATA
WHEN REPLACING EEPROM (MEMORY) IC
INI 3FF data can not be set.
The datas for the address excepting from 3A0 to 3FF are displayed “ERR”. This unit is not defective.