– 30 –
EN
TROUBLESHOOTING GUIDE
Problem
Solution
No power
–Check if the AC power cord is properly connected.
No picture
–Check if the TV is switched on.
–Check if the cable is connected to the correct device.
(See “Connecting to a TV or a stereo TV”)
Distorted picture
–Sometimes a small amount of picture distortion may appear.
This is not a malfunction.
Completely distorted picture or
–Connect VCR/DVD directly to the TV.
black/white picture with DVD
–Make sure the disc is compatible with the VCR/DVD.
No sound or distorted sound
–Adjust the volume.
–Check that the speakers are connected correctly.
–Check if the cable is connected to the correct device.
(See “Connecting to a TV or a stereo TV”)
No audio at digital output
–Check the digital connections.
–Check if the audio format of the selected audio language matches
your receiver capabilities.
No DTS audio at analogue output.
–Use a COAXIAL or OPTICAL DIGITAL AUDIO OUT jack when
outputting the DTS audio.
Picture freezes momentarily
–Check the disc for fingerprints/scratches and
during playback
clean with a soft cloth wiping from centre to edge.
Disc cannot be played
–Ensure the disc label is facing up.
–Check if the disc is defective by trying another disc.
–Handle a disc with special care so that it does not have fingerprints,
scratches or dusts on its surface.
No return to start-up screen when disc is removed
–Reset the VCR/DVD by switching the VCR/DVD off, then on again.
The VCR/DVD does not respond to
–Aim the remote control directly at the sensor on the front of the
the remote control
VCR/DVD.
–Reduce the distance to the VCR/DVD.
–Replace the batteries in the remote control.
–Re-insert the batteries with their polarities (+/– signs) as indicated.
Buttons do not work or VCR/DVD stops
–To completely reset the VCR/DVD, unplug the AC
responding
cord from the AC outlet for 5-10 seconds.
VCR/DVD does not respond to some
–Operations may not be permitted by the disc.
operating commands during playback.
Refer to the instructions of the disc.
VCR/DVD cannot not read CDs/DVDs
–Use a commonly available cleaning CD/DVD to clean the lens
before sending the VCR/DVD for repair.
The VCR does not record a TV programme.
–Make sure the tape has a erase-prevention tab.
–Make sure this VCR/DVD is in VCR mode.
The VCR does not perform a timer recording.
–Make sure the start and the stop recording times are set correctly.
–Make sure the tape has a erase-prevention tab.
–Make sure the clock is set.
–This VCR/DVD may not perform or continue a timer recording if the
power fails for more than 1 hour.
The motor rotates even when tape
–To enable quick play mechanism, the motor will rotate for about 5
playback is stopped.
minutes. This is normal.
You cannot insert a tape.
–Insert a tape with window side up and the erase-prevention tab
facing you.
–Gently push the centre of the tape when putting into the cassette
compartment.
You cannot remove a tape.
–Make sure the power plug is completely connected to a power
outlet.
If the VCR/DVD does not perform properly when operated as instructed in this Operation Manual, check the VCR/DVD, con-
sulting the following checklist.
NOTES:
• Some functions are not available in specific modes, but this is not a malfunction. Read the description in this Operation
Manual for details on correct operations.
• Playback from a desired track and random playback are not available during programme playback.
• Some functions are prohibited on some discs.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
H9745AD(EN)_v2.qx4 04.9.6 13:19 Page 30
