Sharp CD-BA3100, Руководство по эксплуатации

Страница: 13 / 60

ENGLISH
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The “CLOCK” or time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform “Setting the Clock” from the beginning.
If the time display is flashing, step 3 (for selecting the 12-hour or 24-hour display) will
be skipped.
To change the 12-hour or 24-hour display:
1. Clear all the programmed contents.
[Refer to step 3 under “If trouble occurs” on page 27 for details.]
2. Perform “Setting the Clock” from the beginning.
Setting the Clock
In this example, the clock is set for the 12-hour (AM 12:00) display.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button and within 5 seconds, press the
MEMORY/SET button.
3
Press the TUNING/TIME (
X X X X X
or
W W W W W
) button to select the 12-hour or
24-hour display and then press the MEMORY/SET button.
4
Press the TUNING/TIME (
X X X X X
or
W W W W W
) button to adjust the hour and
then press the MEMORY/SET button.
● Press the TUNING/TIME (
X
or
W
) button once to advance the time by 1
hour. Hold it down to advance continuously.
● When the 12-hour display is selected, “AM” will change automatically to “PM”.
5
Press the TUNING/TIME (
X X X X X
or
W W W W W
) button to adjust the minutes
and then press the MEMORY/SET button.
● Press the TUNING/TIME (
X
or
W
) button once to advance the time by 1
minute. Hold it down to change the time in 5-minute intervals.
● The hour will not advance even if minutes advance from “59” to “00”.
● The clock begins counting from “0” seconds. (Seconds are not displayed.)
The time display will disappear after a few seconds.
“AM 12:00”
→
The 12-hour display will appear. (AM 12:00 - PM 11:59)
“AM 0:00”
→
The 12-hour display will appear. (AM 0:00 - PM 11:59)
“0:00”
→
The 24-hour display will appear. (0:00 - 23:59)
Basic Operation
– Setting the Clock –
Note that this can only be set when the unit is first installed or it has been reset.
(Refer to step 3 under “If trouble occurs” on page 27.)
E-12
*BA3100C_EP10_12 01.2.19, 7:25 PM 3