26
A31898,SCA/SCNZ R990C O/M
SERVICE CALL CHECK
Please check the following before calling service:
1. Does the display light?
Yes
No
2. When the door is opened, does the oven lamp light?
Yes
No
3. Place one cup of water (approx. 250 ml) in a glass measuring cup in the oven and close the door securely.
Oven lamp should go off if door is closed properly.
Press the INSTANT COOK/START pad once.
A.
Does the oven lamp light?
Yes
No
B.
Does the cooling fan work?
Yes
No
(Put your hand over the rear ventilation openings.)
C. Does the turntable rotate?
Yes
No
(The turntable can rotate clockwise or counterclockwise. This is quite normal.)
D. Does COOK indicator light?
Yes
No
E.
After 1 minutes, is the water hot?
Yes
No
4. Remove water from the oven and programme the oven for 5 minutes at convection 180
°
C.
A.
Do CONV and COOK indicators light?
Yes
No
B.
After 5 minutes, is the inside of the oven hot?
Yes
No
If "NO" is the answer to any of the above questions, please check your wall socket and the fuse in your meter box.
If both the wall socket and the fuse are functioning properly, CONTACT YOUR NEAREST SERVICE
CENTRE APPROVED BY SHARP.
NOTE: If time in the display is counting down rapidly, check Demonstration Mode. (See P.23 for detail.)
AC Line Voltage:
Single phase
230-240V, 50Hz
AC Power Required:
1.6 kW (Microwave)
1.6 kW (Convection)
Output Power:
Microwave
900 W* (IEC test procedure)
Convection Heater
1500 W
* When tested in accordance with AS/NZS 2895.1.1995
** This is the classification of ISM (Industrial, Scientific and Medical) equipment described in the International
Standard CISPR11.
Microwave Frequency:
2450 MHz**(ClassB/Group2)
Outside Dimensions:
627mm(W) x 378mm(H)
x 487mm(D)
Turntable Diameter:
390mm
Cooking Uniformity:
Turntable system
Weight:
Approx. 29 kg
SPECIFICATIONS
CARE AND CLEANING
Disconnect the power supply cord before cleaning or leave the door open to inactivate the oven.
Before cleaning ensure oven cavity is cool.
CLEAN THE OVEN AT REGULAR INTERVALS
- Keep the oven clean, or it could lead to deterioration of
the surface. This could adversely affect the life of the appliance and possibly result in a hazardous situation.
Exterior:
The outside may be cleaned with mild soap and warm water, wipe clean with a damp cloth. Avoid the use of harsh abrasive cleaners.
Door:
Wipe the door and window on both sides, the door seals and adjacent parts frequently with a damp cloth to
remove any spills or spatters. Do not use abrasive cleaner.
Touch Control Panel:
Wipe the panel with a cloth dampened slightly with water only.
Do not scrub or use any sort of chemical cleaners. Avoid the use of excess water.
Interior walls:
Wipe spatters and spills with a little dish washing liquid on a soft damp cloth for hygienic reasons. For heavier
stains inside the oven cavity only, use a mild stainless steel cleaner applied with a soft damp cloth. Do not
apply to the inside of the door. Wipe clean ensuring all cleaner is removed.
After use wipe the waveguide cover in the oven with a soft damp cloth to remove any food splashes. Built-
up splashes may overheat and begin to smoke or catch fire. Do not remove the waveguide cover.
DO NOT USE CAUSTIC CLEANERS, ABRASIVE OR HARSH CLEANSERS OR SCOURING PADS ON
YOUR OVEN. NEVER SPRAY OVEN CLEANERS DIRECTLY ONTO ANY PART OF YOUR OVEN.
DO NOT USE A STEAM CLEANER. Avoid using excess water. After cleaning the oven, ensure any water is remove with a soft cloth.
Note:
At regular intervals, heat the oven referring to "Heating without Food" on page 10. Because, the splashed dirt
or food oil remained around oven walls may cause the smoke and odour.
Turntable/Turntable Support/Racks:
Wash with mild soapy water and dry thoroughly.
Note:
Keep the waveguide cover and accessories clean at all times. If you leave grease or fat in the cavity or
accessories, it may overheat, cause arching, smoke or even catch fire when next using the oven.
SCA/SCNZ R990C14-26*
03.7.18, 3:52 PM
26
