32
R-930AK
R-930AW
Note:
The door on a microwave oven is designed to act as
an electronic seal preventing the leakage of
microwave energy from oven cavity during cook
cycle. This function does not require that door be
airtight, moisture (condensation)-tight or light-tight.
Therefore, occasional appearance of moisture, light
or sensing of gentle warm air movement around
oven door is not abnormal and do not of themselves
indicate a leakage of microwave energy from oven
cavity. If such were the case, your oven could not
be equipped with a vent, the very purpose of which
is to exhaust the vapor-laden air from the oven
cavity.
Figure C-5. Door Replacement and adjustment
RE-INSTALL
RE-INSTALL
LOWER OVEN HINGE
UPPER OVEN HINGE
DOOR ASSEMBLY
LATCH
HEADS
Remove door assembly, refer to "Door Replacement".
Replacement of door components are as follows:
1. Place door assembly on a soft cloth with latches facing
up.
Note: As the engaging part of choke cover and door panel
are provided at several places, do not force any particular
part.
2. Insert an putty knife (thickness of about 0.5mm) into the
gap between the choke cover and corner portion of door
panel as shown Figure C-6 to free engaging parts.
3. Lift up choke cover.
4. Now choke cover is free from door panel.
DOOR DISASSEMBLY
CHOKE COVER
PUTTY KNIFE
FRONT
INSIDE
Upper
Lower
Bent
Door
Panel
Choke
cover
1 BENT
2 LIFT UP
Figure C-6. Door Disassembly
