AR-N275 UNPACKING AND INSTALLATION - 1
[5] UNPACKING AND INSTALLATION
1. Printer setup
Insert the power plug of the copier to the outlet and turn on the
main switch. Then, carry out the following procedure.
1) Check for the PCL PWB.
Press the PRINT key on the operation panel to check to see if the
copier enters the print mode.
2) Check for printing.
For installation of printer drivers on a computer, see the supplied
operation manual.
Then, connect a parallel cable to the computer and execute print-
ing to check to see if printing can be executed properly.
2. Print server card setup
A. Connection to a network
To connect the print server card to a network, the following items are
required.
• For connection in the 100BASE-TX environment, a hub conforming
to 100BASE-TX and a shield-type, twisted-pair cable (Category 5)
are required.
1) Check that the printer power is off, and connect the shield-type,
twisted-pair cable to the 10/100BASE connector of the print server
card.
2) Connect the other end of the cable to the hub.
3) Turn on the printer power, and check that the printer operates nor-
mally.
B. LAN cable connection and setup
Turn off the main switch of the copier and then remove the power
plug of the copier from the outlet.
1) Connect the cable to the control PWB.
Connect a LAN cable to the connector of the print server card.
Insert the power plug of the copier to the outlet and turn on the
main switch. Then, carry out the following procedure.
2) Check for the print server card.
Use the keys on the operation panel to print a configuration page.
Check that the network interface card has been installed.
3) Check for printing.
Peform setup of the environmental variables.
(For installation of printer drivers on a computer and network set-
tings (IP address input), see the supplied operation manual.)
Execute printing to check to see if printing can be executed prop-
erly.
3. Network scanner setup
This machine allows the use of a network scanner.
If the use of a scanner is disabled for some reasons, reset the machine
in the following procedures:
To enable the scanner function, the product key must be acquired. (For
the method of acquiring the product key, contact the SHARP autho-
rized dealer.)
1) Enable the network scanner feature.
To enable the system configuration, use the keys on the copier to
set the mode.
• Enter the product key.
Enter the product key that has been acquired in the display using
the numeric keys and press the [OK] key.
The message "
SCANNER KEY OK
" will appear in the display.
Setting of the product key is complete. To update the system, press
the [CA] key to exit the setting mode.
2) Paste the label.
If an SPF or RSPF is installed, paste the label on the SPF or
RSPF.
Hub
Shield-type, twisted-pair cable
1 2
3 4
5
6 7
8
LAN cable
2
C
0
6
1
#
Orientation indication label
