Sharp AR-FN6, Руководство по обслуживанию

Страница: 12 / 25

AR-FN6 ADJUSTMENTS-1
[7] ADJUSTMENTS
1. Jogger position adjustment
A. Jogger F/R
1) Staple 5 sheets of A4 or LT paper and check the paper shift (A)
shown in the figure below.
2) If the shift (A) is less than 1mm, there is no need to adjust.
3) If the shift (A) is 1mm or greater, adjust as shown in the table below.
B. Printer model adjustment procedure
1) In the DIAG MODE, select [FINISHER JOGGER ADJ.].
2) Press [OK] key, and the following display will be shown.
Use [ ] key and [ ] key to change the adjustments value.
(Adjustment range: 40 - 60)
3) Change the adjustment value and press OK key, and the stopper will
be turned on and the finisher joggers F/R will move to and stop at the
positions shown in the table below.
4) When the joggers F/R stop, open the door and load A$/LT paper in
the alignment tray, and check the jogger width visually.
5) When the jogger width is too wide or too narrow, use [ ] key and
[ ] key again to change the adjustments value. Press [OK] key to
shift the jogger to the A4/LT alignment position, and check visually.
The table below shows relationship between the adjustment value and
the jogger width.
6) After completion of the adjustment, remove the paper from the
alignment tray and terminate the DIAG MODE.
C. MFP adjustment procedure
1) When the sub code of the simulation is entered, the following display
is shown.
SIM 3-6: Jogger position adjustment
2) Enter the adjustment value with [0] - [9] keys and press START key,
and the menu below will be displayed. (Adjustment range: 40 - 60)
SIM 3-6: Jogger moving
When the stopper is turned on, and finisher joggers F/R move to and
stop at the positions shown in the table below.
3) When the joggers F/R stop, open the door and load A4/LT paper in
the alignment tray, and check the jogger width visually.
4) When the jogger width is too wide or too narrow, use [0] - [9] key
again to change the adjustments value. Press [START] key to shift
the jogger to the A4/LT alignment position, and check visually.
The table below shows relationship between the adjustment value and
the jogger width.
5) After completion of the adjustment, remove the paper from the
alignment tray and terminate the simulation.
Model Adjustment procedure
Pinter model DIAG MODE
[FINISHER JOGGER ADJ.]
(Finisher jogger position adjustment)
MFP SIM 3-6(Built-in finisher jogger position adjustment)
Destination Jogger position
Inch series LT size alignment position
AB series A4 size alignment position
(A)
Staple
Jogger F Jogger R
FINISHER JOGGER ADJ.
ADJUST VALUE
50
Adjustment value Jogger width
Decreased by 1. Increased by about 0.375mm.
Increased by 1. Decreased by about 0.375mm
Destination Jogger position
Inch series LT size alignment position
AB series A4 size alignment position
Adjustment value Jogger width
Decreased by 1. Increased by about 0.375mm.
Increased by 1. Decreased by about 0.375mm
SIMULATION 3-6
FINISHER JOGGER ADJUSTMENT.INPUT VALUE 40-60,AND PRESS START.
50
SIMULATION 3-6
FINISHER JOGGER ADJUSTMENT.MOVING...
50