AR-DU3/DU4/TE3 ADJUSTMENTS 7-1
[7] ADJUSTMENTS
1. Paper guide position adjustment in the
manual paper feed section
(Printer model)
A. Correction value entry procedure
*
This setup is used to enter the detection level to the printer when
installing, etc.
1) Turn the main switch on while pressing the [MENU] key and
the [OK] key of the operation panel of the main unit of the printer.
2) After pressing the [MENU] key several times to display
"SIZE ADJUSTMENT A" in the message display, press the [
] key
to display "SIZE ADJUSTMENT B" and press the [OK] key.
3) "MAXIMUM SIZE" is displayed.
Since "MAXIMUM SIZE" is displayed with a number, press
the [
] key or the [
] key to change the number so that the
number is equal to the value of [MAX] written on the label(*NOTE)
and then press the [OK] key.
4) Since "P1 SIZE" is displayed with a number, press the [
] key or
the [
] key to change the number so that the number is equal to the
value of [P1] written on the label(*NOTE) and then press
the [OK] key.
5) Since "P2 SIZE" is displayed with a number, press the [
] key or
the [
] key to change the number so that the number is equal to the
value of [P2] written on the label(*NOTE) and then press
the [OK] key.
6) Since "MINIMUM SIZE" is displayed with a number, press
the [
] key or the [
] key to change the number so that the
number is equal to the value of [MIN] written on the label (*NOTE)
and then press the [OK] key.
7) Turn off the main switch to cancel the setting mode.
B. Alignment of the guide plate and the size mark
*
This setup is used when the paper width sensor does not work
correctly or when it is replaced with a new one.
1) Press and hold [MENU] key and [OK] key together, and turn on the
main switch.
2) Press [MENU] key several times until "SIZE ADJUSTMENT A" is
displayed. Press the [
] key to display "SIZE ADJUSTMENT C,"
and press [OK] key.
3) "MAXIMUM ISZE" is displayed.
Move the manual feed guide F to the maximum position, and press
[OK] key.
4) "P1 SIZE" is displayed. Move the manual paper feed guide F to the
size mark of A4R on the manual paper feed tray upper, and press
[OK] key.
5) "P2 SIZE" is displayed. Move the manual paper feed guide F to the
size mark of A5R on the manual paper feed tray upper, and press
[OK] key.
6) "MINIMUM SIZE" is displayed. Move the manual paper feed guide F
to the minimum position, and press [OK] key.
7) Turn off the main switch to cancel the setting mode.
"ON"
Label
(*NOTE)
Illustration of label sticking position
MAX
MIN
P1
P2
(Back surface of the bypass tray
extension)
"ON"
Manual paper feed tray upper
(Caution)
Manual paper feed guide F
Paper size mark
5
1
/
2
7
1
/
4
8
1
/
2
11
B5
B4
A4
A3
A4
B5
A5
Manual paper feed guide F
*Align the inside line of the size mark with the paper
guide side of the manual paper feed guide.
Manual paper feed tray upper
Paper size mark
Position of the manual paper feed guide F in setting of
P1 (A4R) and P2 (A5R)
!"#$%
