AR-D15/D20 UNPACKING AND INSTALLATION 4-4
<2>Pull out the upper paper tray of the stand/paper drawer until it stops
and attach the front mounting plates using a supplied screw for each.
Then, remove the lock of the paper tray and close the tray.
<3>Reattach the paper tray of the main unit.
5) Connect the power supply unit harness to the PCU PWB of the main
unit of the printer.
<1>Remove the screw that fixes the harness cover of the main unit of the
printer and slide the harness cover up to remove it.
Process the harness cover as shown in the illustration.
<2>Connect the optional power supply harness connector to CN11
(red connector) of the PCU PWB of the main unit of the printer.
<3>Reattach the harness cover to its original position and fix it with the
removed screw.
At this time, ensure that the optional power supply harness are
arranged as shown in the illustration.
•Fix the harness securely to the wire saddle.
6) Connect the AC cord of the power supply unit to the main unit of the
printer.
Connect the AC cord of the power supply unit to the outlet connector
of the main unit of the printer at the location shown in the illustration.
7) Install the paper guide to the lower tray (large capacity tray).
<1>Remove the four fixing screws for transit.
(Refer to the figure on the below.)
<2>Insert the paper guides L and the paper guides R into the guide
holes in the tray to set the desired paper size. In this case, insert the
paper guide L (with the specified-line label) and the paper guide R
(with the specified-line label) into positions on the inner side. (Refer
to the figure below.)
*
If another peripheral device must be installed, carry out the following
step at the end of the installation work.
Screw
Screw
Front
mounting plate
Front mounting
plate
Harness cover
Cut out.
Screw
Connector
CN11
Wire saddle
Harness cover
Optional power
supply harness
Screw
Wire saddle
AC cord
Paper guide
Paper guide R
(with the specified-line label)
Paper guide R
Paper guide L
Paper guide L
(with the specified-line label)
(For AB series, set to A4. For inch series, set to LT.)
"# $%&'(
