Sharp Aquos LC 37D64U, Руководство по обслуживанию

Страница: 9 / 123

LC-32/37D64U
2 – 3
Hex key
Screws
Soft cushion
1
1
2
2
Attaching/Detaching the Stand
Before attaching (or detaching) the stand, unplug the AC
cord from the AC INPUT terminal.
Before performing work spread cushioning over the base
area to lay the TV on. This will prevent it from being
damaged.
CAUTION
Attach the stand in the correct direction.
Do not remove the stand from the TV unless using an
optional wall mount bracket to mount it.
Be sure to follow the instructions. Incorrect installation
of the stand may result in the TV falling over.
1
Confirm that there are 9 screws supplied with the
stand unit.
2
Attach the supporting post for the stand unit onto
the base using the box for the stand unit as shown
below.
To detach the stand, perform the steps in reverse order.
Vertical mounting Angular mounting
Setting the TV on the Wall
CAUTION
This TV should be mounted on the wall with both
the AN-37AG2 (SHARP) wall mount bracket and the
AN-37P30 (SHARP) attachment of the wall mount
bracket. The TV cannot be mounted when with
only the AN-37AG2 wall mount bracket. The use of
other wall mount brackets may result in an unstable
installation and may cause serious injuries.
Installing the TV requires special skill that should
only be performed by qualified service personnel.
Customers should not attempt to do the work
themselves. SHARP bears no responsibility for
improper mounting or mounting that results in
accident or injury.
Using an optional bracket to mount the TV
You can ask a qualified service professional about
using an optional AN-37AG2 bracket to mount the TV
to the wall.
Carefully read the instructions that come with the
bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket.
(See the bracket instructions for details.)
Detach the cable clamp on the rear of the TV when using
the optional mount bracket.
Due to the terminal configuration on this TV, when you
wall-mount this model, make sure there is enough space
between the wall and the TV for the cables.
To use this TV mounted on a wall, first remove the
adhesive tape at the 4 locations on the rear of the TV, and
then use the screws supplied with the wall mount bracket
to secure the bracket to the rear of the TV.
About setting the TV angle
QUICK REFERENCE
Hex key
Screws
2
3
1
LC-32D64U
The center of the display:
11
/
16
inch (17.3 mm) under
the "A" position.
LC-37D64U
The center of the display:
1 3
/
4
inch (44.1 mm) under
the "A" position.
Refer to the operation
manual of AN-37P30 for
details.
3
Insert the stand into the openings on the bottom
of the TV.
Insert and tighten the 4 screws into the 4 holes
on the rear of the TV.