[ENGLISH]
Contents
1. Part Names
2. Introduction
5. Application
6. Using a PC
7. Appendix
9. Trademarks
Ver. 1.0.0
4P-B50EJ2U, 4P-B55EJ2U and 4P-B65EJ2U
4P-B75EJ2U
Standard screws
M6 (Use 1.0 pitch screws.)
M8 (1.0 pitch)
Length(Depth of
mounting holes)
Upper side
Longer Screws
Length of all screws are same
Lower side
Shorter Screws
Quantity
4 pcs. (set in the box)
4 pcs. (set in the box)
Unit inch (mm)
For the screws, refer to the table shown below.
NOTE
• To use this TV mounted on a wall, remove the cable tie as needed.
• Do not use screws that do not comply with the VESA standard screw specifications.
• Do not use screws that are longer than the standard length. Screws that are too long may cause damage to the inside of the TV.
• Do not fasten the screws too firmly or loosely. This may damage the product or cause the product to fall, leading to personal injury. SHARP is not
liable for these kinds of accidents.
• SHARP is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used, or the consumer fails to follow the
product installation instructions.
Do not install the wall mount kit while your TV is turned on. It may result in personal injury due to electric shock.
• Screws which suits for each models are set in the box.
• Especially, 50”, 55”, 65” models are different length screws required for either upper side and lower side.
• Screws for each upper and lower side are packed to separate bags (50”, 55”, 65” models).
• Please take care length of screws.
- Long length screws: for upper side
- Short length screws: for lower side
For 4P-B50EJ2U, 4P-B55EJ2U and 4P-B65EJ2U
For 4P-B75EJ2U
• Screw length is the same for upper side and lower side.
• 4 pcs. of sleeves are set in the box. Please insert these to each VESA holes before fasten screws.
en-US 56
Setting the TV on the Wall
Appendix
