Sharp AF-Q100VX, Руководство по эксплуатации

Страница: 11 / 20

USING YOUR AIR CONDITIONER
indicatorfan
6
5
3 4
2
1
7
8
Light indicates the unit
is in the temperature or
delay time Set mode.
Power Mode
Fan
Speed
Timer
Filter check
Set
Temp
Cool
Energy Saver
Fan Only
Dry
Auto
High
Med
Low
Time
Electronic Control Panel & Remote Control
CONTROL PANEL
NOTE: This display always shows the room temperature in Fan Mode except when setting the Set temperature or
the Timer
Air Conditioner Controls
1.
Power Button: Turns the air conditioner on
and off
2. Digital Display: Under ON status without timer
setting, the operation mode is Auto, Cool,
Energy Saver or Dry mode, and the set
temperature will be displayed. Under ON status
without timer setting, the operation mode is fan
mode and the ambient temperature will be
displayed. Time will be displayed under timer
setting or timer preview.
3. Temperature Set: Use these buttons on the
control panel and remote to increase or
decrease the Set Temperature (the desired
room temperature) in cooling, energy saver and
dry mode. The SET light will light up when
setting the temperature
4. Timer Set: Use these buttons on the control
panel and remote to set the Timer. Each press
of the Timer (DELAY) buttons will increase or
decrease the timer. For timer instructions
see #7.
5. Fan Speed & Auto Fan: Use the fan speed
buttons to change the fan speed. Choose
between Low, Medium, High, and Auto.
6. Mode Button: Press the mode button to cycle
through the various modes: Cooling, Energy
Saver, Fan only, Dry (Dehumidifier) and Auto.
7. Auto-on Timer: When the air conditioner is
off, it can be set to automatically turn on in
0.5-24 hours at the previous set mode and fan
setting. To set the Auto-on Timer, press the
TIMER button on the unit or remote control.
The timer can be set in 0.5 hour increments
below 10 hours and in 1 hour increments for
10 hours or above. The Set light will turn on
while setting.
Auto-off Timer: When the air conditioner is
on, it can be set to automatically turn off in
0.5-24 hours. To set the Auto-off Timer, press
the TIMER button on the unit or remote
control. The timer can be set in 0.5 hour
increments below 10 hours and in 1 hour
increments for 10 hours or above. The SET
light will turn on while setting.
• To see the remaining time, press the TIMER
Button. To change the timer setting use the
▲/▼ on the unit or the +/- buttons on the
remote.
• During preview of timer or timer setting,
press Timer button on the panel or remote
8. Filter Check: After the fan rotates for 250 total
hours, the filter check light will turn on to
remind the user to clean the filter. Press the
Filter check button once the filter is cleaned to
reset the reminder function.