6
INSTALLATION INSTRUCTIONS
Open the window sash and place the
cabinet on the sill.
Close the window sash securely behind
the top angle.
If there is space between the bottom
channel and the sill, fill the gap with a
thin board or other hard filler.
5
Front panel
Exhaust Lever
Closure assembly
Insert the right closure assembly and the
left closure assembly into the top angle
and the bottom channels.
Secure the right and left closure to the
cabinet with 6 of the provided screws.
(L= / ", 10 mm)
4
32
13
WARNING
Cabinet
sill
incline backwards about 1cm (3/8")
At this step, make sure the cabinet is in-
clined approximately 1 cm (3/8”) to the
back.
If the cabinet is not properly inclined, the
water collected in the bottom tray during
operation will not drain properly and may
flow into the room where the air conditioner
is installed.
(1)
2
Unscrew the 2 screws at the corners of
the front panel. Keep them as they will
be used later.
Remove the front panel by pulling the
front panel at the lower corners towards
you about an inch.
Next lift it up and pull it towards you.
(2)
Take care not to damage the exhaust
lever when removing the front panel.
CAUTION:
Unscrew the 6 stopper screws of the
cabinet. Keep the 4 screws from the
top and front , as they will be used later.
Slide the chassis out from the cabinet
by pulling on the hand hold located at
the bottom center of the chassis.
(1)
3
(2)
Do not remove any material (ex.
styrofoam, etc.) from inside the unit.
CAUTION:
Front
panel
Horizontal
Louver
