INCLUDED COMPONENTS
or
3pcs
4pcs
1pcs
4pcs
4pcs
4pcs
1pcs
1pcs
a
TOOLS REQUIRED
BEFORE STARTING ASSEMBLY MAKE SURE ALL COMPONENTS LISTED ARE IN THE PACKAGE
! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
b
c
d
e
4pcs
f
h
g
4pcs
i
a
a
a
b
g
h
φ
8mm
45mm
f
e
c
Tape measure
Hammer
screwdriver
Pencil
Electric drill
Levelling instrument
d
d
d
b
1. Remove the short screw (d) near the power cable of towel warmer.
2. Insert the short screw (d) through the hole of the wall bracket (b).
3. Screw down the short screw (d) by screwdriver to fix the wall bracket (b) on the back of towel warmer.
Note: When installing the unit, the set screw of the bracket should towards the floor.
4. Fix the remaining three brackets (a) to the towel warmer by repeating step 2 to 3.
5. Use tape measure to measure and confirm the distance between these four wall bracket,
and then mark A, B, C, D on the wall.
Suggest it is installed at least 600mm above the floor level, and try to use the levelling instrument to
test the levelness and perpendicularity.
6. Drill holes on the wall marked A, B, C, D.
7. Use hammer to knock plastic expander (f) into wall completely. And the insert long screw (c)
through short tube (e), then screw into plastic expander (f).
7. Use hammer to knock plastic expander (f) into wall completely. and the insert long screw (c)
through short tube (e), then screw into plastic expander (f).
8. Install the bracket onto the short tube (e), install the set screw (h) into the hole of the bracket
(a+b) using the allen wrench; fix the bracket (a+b) onto the short tube (e).
9. Fix the remaining three brackets by repeating step 8.
10. The installation is finished. Then wipe the tubs cleanly.
INSTALLATION STEPS
&
i
h
Set screw
c
Long screw nail
f
Plastic expander
d
Short screw
g
Allen Wrench
Wall hang bracket
a
b
+
e
Short tube
Replacement