Before adjusting the speed idling engine is warm.
CUTTING (USE CUTTING HEAD)
WARNING
1. Always wear safety goggles. Never lean over the
rotating cutting head. Stones or other debris could be
thrown into eyes and face and cause serious personal
injury.
2. When the unit is used to keep constantly attached guard
against fragmentation is always in place.
Grass and weed growth
• Keep in mind that cutting is the end of the line. Achieve
better results, if there is no accumulation of lines in the
chipping. Allow the unit to mow her own speed.
1. Hold the unit so that the head was above ground tilted in the direction of contact angle of 20
degrees (GP7).
2. Mowing from left to right, you can prevent ejection of debris.
3. When cutting heavy vegetation Use a slow, thoughtful motion. The speed of movement depends on
the chopping chopped material. Heavy growth will require slower motion than lighter vegetation.
4. Never drive too Do not wiggle, you can, loss of balance control over the unit, get into a dangerous
situation.
5. Experiment control the movement of chopping motion of the hips than placing the full workload on
the hands and arms.
6. Be careful not to get entangled in the wire, weeds, dead, dry vegetation around long cutting head.
Such materials may stop head and jam the clutch, which may result in jamming of the system, if it
happens regularly.
CABLE ADJUSTMENT
• Your brush cutter is equipped with a type of semi-automatic head with a nylon cord that allows the
operator to move the cord without stopping the engine. When the cord is short, lightly tap his head on
the ground while the engine is running at full throttle.
• Whenever tapping head will extend the cords by about 1 "(25.4 mm). For better effect, tap the head
on the side, already mowed surface or hard ground. Avoid knocking into the thick, tall grass, it may be
caused by overloading the engine stops.
420 774 335 397 www.sharks-shop.cz Stránka 55
