420 774 335 397 www.sharks-
shop.cz Stránka 23
FUNCTIONAL CAUTION:
DECRTIPTION
Always be sure that the tool is switched off and unplugged before adjusting or
checking function on the tool.
Switch action
CAUTION:
Before plugging in the tool, always check to see that the switch
trigger actuates properly and returns to the „OFF“ position when released.
TO start the tool, simply pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operatin, pull the switch trigger and thed push the lock lever
upward.
To stop the tool from the locked position, pull the switch trigger fully, then
release it.
Reversing switch action
This tool has a reversing switch to change the direction of rotation. Move the
reversing switch lever to the ← position (A side) for clockwise rotation or the →
position (B side) for counterclockwise rotation.
1. Reversing
CAUTION:
switch lever
● Always check the direction of rotation before operation.
● Use the reversing switch only after the tool come to a complete stop.
Changing the direction of rotation before the tool stops may damage the tool.
Installing or removing drill bit
For Rubber Chuck
Hold the ring and turn the sleece counterclockwise to open the chuck jaws.
Place the but in the chuck as far as it will go. Hold the ring firmly and turn the
sleeve clockwise to tighten the chuck.
To remove the bit, hold the ring and turn the sleeve counterclovkwise.
For Iron Chuck
To install the bit, place it in the chuck as far as it will go. Tighten the chuck by
hand. Place the chuck key in each of the three holes and tighten clockwise.
Be sure to tighten all three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just one hole, then
loosen the chuck by hand.
After using the chuck key, be sure to return to the original positon,
