420 774 335 397 www.sharks-shop.cz Stránka 24
5
）
If welding time is exceeded duty cycle limited, welding machine will stop working for protection.
Because machine is overheated, temperature control switch is on “ON'' position and the indicator light
is red. In this situation, you don't have to pull the plug, in order to let the fan cool the machine. When
the indicator light is off, and the temperature goes down to the standard range, it can weld again.
QUESTIONS TO BE RUN INTO DURING WELDING
Fittings, welding materials, environment factor, supply powers maybe have something to do with
welding. User must try to improve welding environment.
A. Black welding spot
--Welding spot is not prevented from oxidizing .User may check as following :
1. Make sure the valve of argon cylinder is opened and its pressure is enough. argon cylinder must be
filled up to enough pressure again if pressure of cylinder is be low 0.5Mpa .
2. Check if the flow meter is opened and has enough flow .User can choose different flow according
to welding current in order to save gas .But too small flow maybe cause black welding spot because
preventive gas is too short to cover welding spot .We suggest that flow of argon must be kept min
5L/min.
3. Check if torch is in block .
4. If gas circuit is not air-tight or gas is not pure can lower welding quality .
5. If air is flowing powerfully in welding environment ,that can lower welding quality .
B
、
Arc-striking is difficult and easy to pause
1. Make sure quality of tungsten electrode is high .
Grind end of the tungsten electrode to taper .If tungsten electrode is not grinded ,that will be
difficult to strike arc and cause unstable arc .
C
、
Output current not to rated value
：
When power voltage departs from the rated value, it will make the output current not matched with
rated value; When voltage is lower than rated value, the max output may lower than rated value.
D
、
Current is not stabilizing when machine is been operating
：
It has something with factors as following :
Electric wire net voltage has been changed .
There is harmful interference from electric wire net or other equipment .
E
、
When use MMA welding,too much spatter.
Maybe current is too big and stick’s diameter is too small
；
Output terminal polarity connection is wrong, it should apply the opposite polarity at the normal
technics, which means that the stick should be connected with the negative polarity of power source,
and work piece should be connected with the positive polarity. So please change the polarity.
BEFORE CHECKING
WARNING
Blind experiment and careless repair may lead to more problem of the machine that will
make formal check and repair more difficult. When the machine is electrified, the naked
parts contain life-threatening voltage. Any direct and indirect touch will cause electric shock,
and severe electric shock will lead to death.