SHARKS Airstation SHK 476, Инструкция по эксплуатации и обслуживанию

Страница: 32 / 40

420 774 335 397 www.sharks-shop.cz Stránka 32
● Check for correspondence between the compressor plate data with the actual specifications of the
electrical system.
● Insert the plug of the electrical cable in a socket of suitable shape, voltage and frequency
complying with current regulations.
● Use extension cables with a maximum length of 5 meters and with a cable cross-section
of not less than 1.5 mm2. Use of extension cables of different length and cross-section
and also of adapters and multiple sockets should be avoided.
● Always use the handle to move the compressor.
● Attention! Never operate the compressor respectively. Do not turn off with a plug. Always use a
dedicated switch. Never use the device if the switch is not functional.
● Once the device is not in use, unplug it from the mains. It could become a source of danger.
● At the completion of the compressor to turn off the switch, drain the air tank and compressor unplug.
● Caution: not omitting the condensed water can cause corrosion inside the tank and thus reduce its
performance and jeopardize safety.
● DISPOSAL condensed water in accordance to applicable standards for environmental protection,
since it is a pollutant.
● Near the compressor or compressor not place flammable objects or objects made of nylon or fabric.
●
Do not block the air vents of the compressor.
● The compressor is designed for domestic use only, When used for industrial purposes for faults not
covered by warranty.
● The compressed air, which produces the compressor can not be used for pharmaceutical and food
purposes and not used for filling diving bottles.
● When using compressed air, you must know and comply with the safety precautions to be
adopted for each type of application (inflation, airpowered tools, painting, washing with
water-based detergents only, clinching, etc.).
●
To avoid overheating of the electric motor, this compressor is designed for intermittent
duty operation. Overload the engine, take regular breaks. Recommendation ratio: 2,5 minutes working
and 7,5 minutes operation breaks.
Failure to observe regular breaks to avoid irreversible engine damage not covered by warranty.
●
The coating should in any case use filtered water separator.
● To select a suitable pneumatic tools is essential that the consumption of air tools and effective
quantity supplied compressor.
● Never direct the jet of air towards persons, animals or your body.
●
Never let the compressor come into contact with water or other liquids and never direct the jet of
liquids sprayed by tools connected to the compressor towards the compressor: as the appliance is
live, this could cause electrocution or short-circuits.
● Never use the appliance with bare feet or wet hands or feet.
●
Never yank the power cable to disconnect the plug from the power outlet or to move the
compressor.
● Never leave the appliance exposed to adverse weather conditions (rain, sun, fog, snow).
● If this compressor is used outdoors, always remember to stow it after use in a covered or closed
place.
● Never use the compressor outdoors in rain or bad weather.
Reguirements for operating staff
The operating staff must carefully read the Operating Instructions before using the appliance.
Qualification: Apart from the detailed instructions by a professional, no special qualification is
necessary for appliance using.
Minimum age: Personf over 16 years of age can only work on the appliance. An exception includes
youngsters trained in order to reach knowledge under supervision of the trainer during occupational
education.
Training: Using the appliance only requires corresponding training by a professional of the Operating
Instructions. No special training is necessary.