SharkRF openSPOT3, Руководство пользователя

Страница: 89 / 131

FCS connector
You can use this connector to connect to a network which supports the FCS protocol like the FCS network.
The easiest way is to use the Quick setup to connect to these networks.
You can change rooms with your C4FM radio by entering the Special command/cross mode private call DTMF
code DTMF code (by default it's *) or the Cross mode group call DTMF code] (by default it's #) followed by the
special ID described below.
You can also use the Wires-X® button menu of your C4FM radio to select/search for servers.
Cross mode usage
The FCS connector is a C4FM connector, but it supports DMR, D-STAR®, NXDN® and P25 cross modes.
Server and room change using a DMR, NXDN® or P25 radio
You can change servers and rooms using your DMR, NXDN® or P25 radio with a private call to a special ID
described below.
Server and room change using a D-STAR® radio
DTMF method
Enter DTMF code * followed by the special ID described below.
URCALL/your call method
Set the URCALL to the FCS server and room number. Example: starting a call to destination callsign (URCALL)
FCS00199
switches to FCS001 room 99.
The URCALL/your call method lets you change to the following server types:
REF/XRX/Gateway: set the URCALL to for example
REF001 C
. Switching to REF/XRF servers or gateways this
way changes the openSPOT3's active connector to the REF/XRF connector .
DCS/XLX: set the URCALL to for example
DCS001 A
. Switching to DCS/XLX servers this way changes the
openSPOT3's active connector to the DCS/XLX connector .
BrandMeister: set the URCALL to
BM
followed by the BrandMeister server ID. Example: starting a call to
FCS
89