Control calls
There are some special IDs and callsigns which trigger built-in services and actions when a call is received to
them from your radio.
Local echo service
If the local echo service's ID or callsign is called, the openSPOT3 records the voice transmission and plays it back
after the call from the radio is finished. This is useful for hearing your own voice back to test the connection
between your radio and the openSPOT3. If you have local echo voice quality issues, see the
connector.
The local echo service can be triggered if the call is sent to the following IDs/callsigns:
and
:** ID 9999. Both private and group calls to this ID are answered with a private call.
: call is sent to
.......E
(7 spaces and an E, replace dots with spaces). Note that currently the D-
STAR® echo reply is limited around 2 seconds.
: call DGID is set to 99.
Note that only about 10 seconds can be recorded and played back by the local echo service.
Current configuration profile query
The current configuration profile's number can be queried by calling the following IDs/callsigns:
DMR, NXDN® and P25:
ID 9000. Both private and group calls are interpreted.
D-STAR®:
call is sent to
.......P
(7 spaces and an P, replace dots with spaces), or DTMF code A is entered.
C4FM:
Special command/cross mode private call DTMF code
(by default it's *) is entered followed by DTMF
code A.
The current configuration profile number will be announced by the voice. The DMR/NXDN®/P25 profile query ID
can be changed on the Settings page,
section.
Change configuration profile
The active configuration profile can be changed by calling the following IDs/callsigns:
DMR, NXDN® and P25:
ID 9000+configuration profile number. Example: to switch to config profile 1, start a
short call to 9001. Both private and group calls are interpreted.
D-STAR®
: call is sent to
.......1
(7 spaces and the configuration profile number, replace dots with spaces),
or DTMF code A is entered followed by the configuration profile number.
C4FM:
Special command/cross mode private call DTMF code
(by default it's *) is entered followed by DTMF
code A, then the desired configuration profile number.
Connector status query
The currently active connector's status can be queried by calling the following IDs/callsigns:
DMR, NXDN® and P25:
ID 9998. Both private and group calls are interpreted.
D-STAR®:
call is sent to
.......I
(7 spaces and an I, replace dots with spaces), or DTMF code D or 0 is
entered.
C4FM:
Special command/cross mode private call DTMF code
(by default it's *) is entered followed by DTMF
code D.
Control calls
104
Содержание openSPOT3
