Shark V1917, Руководство пользователя, Страница: 6 / 8

Fig. 2
Charging
Light
Indicator
Charging Instructions
1. Connect the charger plug to the charging jack or hole on the side of the sweeper.
Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only
charger
KA12D075015023U . (Fig. 2)
4
OPERATING INSTRUCTIONS
Changing The Rotating Brush, Gear Box & Squeegee
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must
be charged for a minimum 20 hours.
3. When recharging the unit, the "On/Off" switch must be in the "OFF" position.
4. The charging light indicator on the top of the sweeper will illuminate to indicate
that the sweeper is properly charging.
5. To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
Note: If, when you place the sweeper to recharge and the charging indicator light does
NOT illuminate, then press the On/Off button once to turn the sweeper off. The
charging indicator light should now light up.
Note: Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
Important:
To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely re-charged at least
once a month.
1. Remove the extension tube handle from the sweeper power head.
2. Turn the sweeper power head upside down being careful not to accidentally turn
the unit “On”.
3. Remove the brush cover.
4. Push in on the locking tab of the gear box and lift the gear box to remove.
(Fig. 12 & Fig 13)
Lift
Fig. 13
9
OPERATING INSTRUCTIONS
Fig. 15
Fig. 14
Fig. 12
Locking
tab
Gear box
Gear box
tabs
5. Lift the brush bar end cap up from the slot. (Fig. 14)
6. Pull the brush bar out from the bushing and slip off the belt to remove the brush
bar. (Fig. 15)
7. Insert the new brush bar by first inserting the brush bar into the bushing on the end
opposite the driver belt (Fig. 15)
Caution:
• Use only the adaptor supplied with the sweeper.
• Do not clean the sweeper while unit is charging.
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage the battery casing.