Shark S3455SL, Руководство пользователя

Страница: 7 / 9

8 9
CARE OF YOUR CLEANING POCKET
1
We recommend washing your cleaning pocket
separately from other fabrics to avoid picking up
lint.
Only use liquid detergent (no powder
detergent). Do not use any fabric softeners or
bleach.
For optimal cleaning performance pockets
may need to be washed up to (3) three times. Line
dry. Do not tumble dry.
(fig. 14)
2
If there are loose threads on the microfibre cleaning
pocket carefully cut the thread with scissors. Do not
pull on them or cut at the base.
(fig. 15)
DECALCIFYING YOUR STEAM MOP
Calcium and mineral deposits can build up and impact
the performance of your steam mop over time.
CLEANING THE NOZZLE
Your steam mop should not normally require
cleaning, however, should you notice a decrease in
the steam output, it may be necessary to remove
mineral deposits built up around the nozzle.
1
Unplug the steam mop from the electrical outlet.
2
Use a small diameter stiff metal wire, such as a
straightened metal paperclip, and carefully insert the
end of the
wire into the nozzle orifice. (fig. 16)
3
Move the wire back and forth several times to
remove any deposits.
4
Plug the steam mop in to the power outlet and test
steam output.
Care of Your Steam Mop - cont.
fig. 14
fig. 15
fig. 16
40°
Troubleshooting Guide
PROBLEM POSSIBLE REASONS & SOLUTIONS
The Shark
®
Slim Professional
Steam Pocket
®
Mop will not
turn-on.
Your steam mop should be securely plugged into an electrical outlet only.
Check your fuse or breaker.
The unit will not make steam.
Is there water in the water tank? If not, add water to your steam mop following
instructions on page 4.
If the unit still doesn’t make steam, follow the decalcification instructions on
page 8.
Cannot select steam setting/
flashing blue light remains on.
If you have already plugged in your unit, unplug and try a different outlet. This
may reset the Standby mode.
Add water to the tank and press the STEAM CONTROL button to select a
steam setting.
The Shark
®
Slim Professional
Steam Pocket
®
Mop leaves
water on the floor.
Check to see if your cleaning pocket is soaked through. We recommend you
unplug the steam mop and change the cleaning pocket.
Make sure the cleaning pocket is attached correctly.
The Shark
®
Slim Professional
Steam Pocket
®
Mop left a white
spot on the floor.
Do not leave your steam mop on the floor with a damp or wet cleaning pocket.
If you’re using tap water we recommend switching to distilled water.
Make sure the cap is securely on the water tank.
Floors are cloudy, streaky or
spotty after steaming.
The cleaning pocket might be dirty, change the cleaning pocket.
If you washed the cleaning pocket with powder detergent, then it might be
ruined.
You might have left the mop in the same spot for too long. Do you have hard
water? If you do, you might want to switch to distilled water.
This might be leftover from past cleaners used on the floor surface. Use the
steam mop a few more times and see if the leftover cloudiness is removed. If
this does not work, we suggest rinsing the floor with water, letting it dry, and
then steam mopping again with a clean pocket. One or more rinses generally
removes the residue. A more stubborn case may require you to rinse the floor
with a mix of one part vinegar and two parts water.
The Shark
®
Slim Professional
Steam Pocket
®
Mop is hard to
push.
Make sure the cleaning pocket is attached correctly.
Check to see if the cleaning pocket is excessively dirty. Replace if the cleaning
pocket is too dirty or wet.