Shark Rocket HV320REF, Руководство пользователя

Страница: 9 / 12

Empty
Empty
Dust Cup
Release
STEP 1
STEP 2
9
8 0 0.7 9 8.73 9 8
To keep your vacuum’s suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
EMPTY THE DUST CUP
1
Press the WAND RELEASE button on
the top of the wand to disconnect it
from the handheld portion.
OR
Remove the dust cup from the
handheld vacuum by squeezing the
two DUST CUP RELEASE buttons on
both sides of the base at the same
time and pulling it out.
2 Hold dust cup over a trash bin and
press the EMPTY button on the front
of the dust cup. The bottom lid will
open, allowing the debris to fall out.
NOTE: Clean the dust screen inside the
dust cup as required.
3
Once dust cup is empty, close the
bottom lid and insert dust cup back
into handheld and you will hear it
click into place.
NOTE: Empty dust cup when debris
reaches the MAX fill line.
CLEAN THE FILTERS
1
Access the Pre-Motor foam and
felt filters by lifting the latch on
the top of the handheld vacuum.
Remove and hand wash them every
month. Let air dry completely before
replacing. Tap loose dirt off filters
between washes as needed. Insert
the felt filter first and then place the
foam filter on top of it.
2 Access the Post-Motor filter under
the handle. Remove and hand wash
once a year. Let air dry completely
before replacing.
TO CHECK FOR BLOCKAGES, REMOVE
AND INSPECT:
HANDHELD AND WAND
1
Remove the wand from the
handheld portion and check all dust
cup intake openings.
2 Remove the floor nozzle from the
wand and check the wand for
blockages.
BOTTOM OF FLOOR NOZZLE
1
Use a coin to unlock the three locks
on the bottom of the floor nozzle.
2 A portion of the base is removable
to allow for better access to the
brushroll and exposure to the
airway. Shine a flashlight from
the bottom to check for possible
blockage in the airway.
3 Remove any string, carpet fibers or
hair that may be wrapped around
the brushroll. There is a groove
along the brush bar that allows a
pair of scissors to cut across it to
loosen up the debris.
4 To re-assemble, replace base by
lining it up along the front of the
nozzle. Push down to snap into place
until you hear a click. Lock the three
locks.
Monthly
Post-Motor filter
(1084FTV320)
Pre-Motor filters
(1080FTV320)
Foam
Felt
MAINTENANCE