Shark RG-232637, Руководство по обслуживанию, Страница: 8 / 12

9.801-589.0 • RG-232637 • Rev. 06/14
PRESSURE
W
ASHER
T
roub
leshooting Guide
8
PROBLEM POSSIBLE CAUSE SOLUTION
ENGINE OPERATES
FOR 15 MINUTES
THEN STOPS Not enough gas or engine oil Fill tank with gas. Check oil level.
Vapor lock developed by heat of day Keep gas tank full to avoid vapor locking.
Obstruction in fuel fi lter Clean or replace fuel fi lter.
ENGINE LACKS
POWER Dirty air fi lter Replace air fi lter.
ENGINE FALTERS
Choke is opened too soon Move choke to halfway position until engine
runs smoothly.
WATER DRIPPING
FROM UNDER PUMP Piston packing worn Call local distributor.
O-Ring plunger retainer worn Call local distributor.
Cracked piston Call local distributor.
OIL DRIPPING Oil seal worn or damaged Call local distributor.
WATER LEAKING
FROM PUMP
PROTECTOR Spray gun closed with machine
running 5 minutes or longer Open spray gun or turn off machine.
Excess water supply pressure Place a pressure regulator at end of 50'
garden hose.
NO DETERGENT Detergent suction tube not properly
connected to machine Check connection.
Detergent is too thick Dilute detergent. For best results, use
manufacturers detergent.
Detergent fi lter valve is at lowest
setting Set detergent fi lter valve to a higher setting.
Filter on detergent suction tube is
clogged Run warm water through fi lter to remove
debris.
Damaged or clogged detergent suc-
tion tube Remove obstruction or replace detergent
suction tube.
A high pressure nozzle is attached. Replace with black detergent nozzle.
Discharge nozzle is obstructed Blow out or remove debris with fi ne needle.
GARDEN HOSE
CONNECTION
LEAKS Loose fi ttings Tighten fi ttings.
Missing/worn rubber washer Insert new washer.
SPRAY WAND
LEAKS Spray wand not properly attached Slide the spray wand into the gun. Turn the
wand collar clockwise onto the spray gun
threads until tight.
Broken o-ring Call local distributor and order an o-ring.
PUMP IS NOISY
Pump is sucking air Check that hoses and fi ttings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady fl ow of
water emerges through nozzle.
TROUBLESHOOTING