OPERATING INSTRUCTIONS
GETTING TO KNOW YOUR GRAB N’ BAG POWERED
SCOOPER
Fig. 4
Side Locking
Tabs
Center
Locking Tab
Fig. 2
Fig. 3
4. To close battery cover align the arrow
on the cap with the arrow on the handle
and twist clockwise to lock.
To attach the large scoop onto the unit:
1. Hold the large scoop in your hand and
slide onto the main unit. Make
sure that the center locking tab
and the side locking tabs
are on the inside of the unit
walls. (Fig. 4)
2. To use the bags, press the spool
release button and pull gently on bag
until desired length is reached.
3. Before use, open bag and pull over bar.
(Fig. 7, Fig. 8) Make sure that the end
of the bag covers the entire area of the
scoop.
Fig. 7
Fig. 8
Inserting the Bag Spool
1. To install bags align the outer tip of the
roll with the recessed hole in the bag
compartment and simply press inward.
Adjust the grooved side of the bag roll
with the opposite side of the bag
compartment (Fig. 6)
Fig. 6
The Power Scooper uses 4 AAA Alkaline
batteries to power the unit.
1. Push the handle release button and lift
the handle of the unit. (Fig. 1)
2. To remove the battery compartment
cover, twist cover CCW (Fig. 2)
3. Insert the 4 AAA batteries making
sure that the “+” and “-” poles are
inserted in the correct direction. (Fig. 3)
Fig. 1
Lift
Assembling Your Power Scooper
To remove the large scoop from the unit:
1. Hold the unit in your hand and push the
center tab up from the bottom to
release. (Fig. 5) Slide the large scoop
out.
Fig. 5
Push In
9.
Bag Compartment
10. Standard Scoop
11. Large Scoop With Tread Base
12. Attachment Tab
13. Side Locking Tab
14. Bag Spools (not shown)
15. Strap (not shown)
16. 4 AAA Batteries (*
Not illustrated)
1. Battery Cover
2. Battery Compartment
3. Soft Grip Handle
4. Power Button
5. Spool Release Button
6. Handle Release
7. Front Bag Bar
8. On-Board Light
Illustrations may differ from actual product.
Technical Specifications
Power:
6 Volt DC
NOTE
: Never use unit without a bag in
place.
2
3