10
unit above the Wrinkle Eraser
™
into the notch. Next, secure
the pointed end of the frame
around the bottom of the unit
and snap into place (
Fig. 2
).
When using the upholstery/
delicate fabric frame:
NOTE:
Remember, DO NOT use
the garment steamer without
the small steam bonnet in place
4
Attach the desired bonnet to
the frame, then attach the
frame to the unit. Pull either
side of the bonnet over the top
of the frame and secure the
bottom of the bonnet to the
frame (
Fig. 3
). Then attach the
frame to the garment steamer
as described above (
Fig. 4
).
Using Your Press & Refresh
™
Attaching the accessories:
IMPORTANT:
Use caution
when changing the frames
when the unit is hot. The
frames are designed with a
steam guard around the bottom
to provide protection from heat
when placing or removing the
frames.
The small steam bonnet must
be attached at all times during
usage.
The bonnet should only be
removed for washing by hand,
if necessary (see page 13 for
care instructions).
3
Choose your desired frame.
Using both hands, hold the
frame on either side. Attach
the top of the frame to the
Filling and refilling the water
reservoir:
1
Never fill the garment steamer
while it is plugged into an
electrical outlet.
2
Open the water cap and hold
the the garment steamer
horizontally with the Wrinkle
Eraser
™
parallel to the floor.
Using the filling flask provided
fill the water tank to the Max
Fill line. Be careful not to
overfill. Push the cap back into
place, making sure it closes
firmly (
Fig. 1
).
NOTE:
The water tank does not
have to be completely full for
the fabric steamer to generate
steam. However, make sure
that the water tank is at least
half way full for optimal results.
Practice makes perfect!
It takes time to master
the garment steaming
techniques.
For best results, tilt the
steamer forward slightly
and press the wrinkle
eraser directly on the
garment.
Fig. 1
Fig. 2
Fig. 4
Fig. 3
The seam on the frame must line up
with the seam on the unit for proper
use and safety. The frame will snap into
place, double check to make sure the
seams are aligned.
GS500Q_IB_ES_101123.indd 10
10-11-24 10:11 AM
