AU
02 8 8 01 76 6 6
NZ
0 8 0 0 112 6 60
AU
sharkclean .com . au
NZ
sharkclean .co. nz
AVAILABLE ACCESSORIES
A
C
A
Crevice Tool
Clean in corners and other tight spaces, or
reach skirting boards and ceilings with this
slim crevice tool.
B
Pet Power Brush
Picks up pet hair and loose debris, and
powerfully deep-cleans dander out of
upholstery and other surfaces.
C
Pet Multi-Tool
A single convertible tool for cleaning tough
pet messes two ways: use the stiff bristle
brush to clean stuck-on debris, or take off
the bristles to reveal an upholstery tool
perfect for removing stubborn pet hair and
large piles of debris.
NOTE:
Not all accessories come with all units. Please refer to the
packaging panels
for your unit's configuration.
To order additional accessories, visit
AU sharkclean.com.au NZ sharkclean.co.nz
B
TROUBLESHOOTING
Vacuum is not picking up debris. No suction or light suction.
•
Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the
filters before reinserting in the vacuum.
•
Dust cup may be full; empty dust cup.
•
Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any
blockages found.
(Refer to Checking for Blockages section for more information.)
•
If any string, carpet fibers, or hair is wrapped around the brushroll, extend cleaning time to
allow the self-cleaning brushroll to remove it.
– If some hair or fibers remain wrapped around brushroll after continued use, remove the
floor nozzle cover and carefully cut debris with scissors and remove from brushroll. See
Maintenance section for more information.
Vacuum lifts area rugs.
•
Make sure Power/Surface switch is set to Hard Floor (setting I).
•
Reduce suction slide to the 'MIN' setting.
Brushroll does not spin in carpet cleaning mode.
•
If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum.
Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum,
and turn on power.
•
With the power on, recline the handle, which will automatically turn on the brushroll.
•
Ensure that the Power/Surface switch is set to Carpet (setting II) for brushroll
to spin.
Vacuum turns off on its own or indicator light flashes red.
If your vacuum overheats, the thermostat will automatically turn the suction motor off. Perform
the following steps to restart the thermostat:
1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters (see Emptying the Dust Cup and Cleaning and
Replacing the Filters.).
3. Check for blockages in hose, wand, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 60 minutes.
5. Plug in vacuum and turn it on.
For all other issues, please call Customer Service
AU 02 8801 7666
or
NZ 0800 112 660
.
