Shark NV100UKL, Руководство пользователя, Страница: 12 / 16

10
www.lakeland.co.uk
Checking for Blockages
Blockages may cause your vacuum
to overheat and shut down. If
this occurs, clear the blockages,
then follow the instructions for
Resetting the Motor Thermostat
on page 11.
IMPORTANT:
Never insert sharp
objects into any opening to clear
an obstruction. Damages caused
while clearing or attempting to
clear blockages are not covered
under your product’s limited
warranty.
Unplug the vacuum
before checking for
blockages.
Reassemble all parts
securely before
operating vacuum.
1
2
3
1 DUST CUP AIR DUCT:
Stand vacuum upright.
Remove Dust Cup Assembly and
empty Dust Cup if necessary.
Check Air Duct behind Dust Cup
for clogs; clear before replacing
Dust Cup Assembly. (
Fig. 21 )
2 HOSE INTAKE OPENING:
Hold the top of the hose access
door and pull firmly to remove.
Slide the knob to the center and
pull out the hose. (
Fig. 22 )
Remove any obstructions and
push the hose back in.
Slide the knob to the left and
snap the hose access door shut.
3 HOSE:
Disconnect the Stretch Hose by
gently pressing the tabs together
and pulling away from the hose
connector.
Remove hose from both the unit
and handle ends. (
Fig. 23 )
Inspect the length of the hose
and remove any obstuctions.
Fig. 21
Fig. 22
Fig. 23
NV100UKL_26_IB_ENG_120305_1.indd 10 12-03-05 11:13 AM