7
8
1-800-798-7398
sharkclean .com
USING YOUR VACUUM IN UPRIGHT MODE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
ASSEMBLY
1
Place the floor nozzle on
a level surface. Align the
opening on the Lift-Away
®
pod with the tube on the
floor nozzle, then lower
pod until it clicks into
place.
When attaching the
motorized floor nozzle,
ensure that the latching
mechanism is fully
locked in place to ensure
electrical connection has
been made.
USAGE
1
Quickly release the power
cord by rotating the upper
cord hook located on the
back of the wand.
2
Press the ON/OFF switch
to the Suction Only (
I
)
position to vacuum bare
floors or to the (
II
) position
to engage the motorized
brushroll for vacuuming
carpets and rugs.
2
Attach the end of the
extension wand to the
tube on the back of the
Lift-Away pod until it clicks
into place.
3
Slide the accessory holder
(positioned opposite the
upper cord wrap) over the
extension wand. Align the
tab with the groove and
push down.
II
Brushroll ON (Carpets & Area Rugs)
I
Suction Only (Bare Floors)
O
OFF
3
Gently press the floor
nozzle down with your foot
while you grasp the handle
and tilt it back towards
you.
NOTE: The brushroll will
not spin unless the nozzle
is flat against the floor and
the handle is tilted back.
4
When you are finished
vacuuming, turn the
vacuum off.
WARNING:
The ON/OFF
switch is located on the
top of the Lift-Away
®
Pod.
Always ensure the power
is set to the OFF (
O
)
position before plugging in
or unplugging.
WARNING:
To reduce
the risk of electric shock,
unplug the unit before
assembling, adding or
removing attachments, or
converting modes.
4
Push the handle onto the
top of the extension wand
until you hear it click into
place. Insert the end of
the stretch hose into the
connector on the back of
the Lift-Away
®
pod.
5
Store the dusting brush
and the crevice tool on the
mounts on the accessory
holder.
WHAT DOES THE
BRUSHROLL INDICATOR
LIGHT MEAN?
Solid Green
The brushroll is on and
working as it should.
Solid Red
There is a jam in the brushroll
area. Turn your vacuum off
and remove the blockage.
Flashing Red*
The motorized floor nozzle
is overheating. Turn your
vacuum off and wait for it to
cool down. Next time you are
vacuuming that surface, try
opening the Suction Control.
No Light
The brushroll is off because the
vacuum is in Hard Floor mode.
* See Troubleshooting section for
further instructions.
