Shark Navigator Lift-Away NV355, Руководство пользователя

Страница: 12 / 20

Fig. 18
Dust-Away
™
Hard Floor Attachment - Use and Care
ATTACH PAD
Slip two of the tabs between the suction nozzle
and the
Dust-Away
™
base and attach them to
the front fasteners on the base. Then pull the
other two tabs tightly around to the back fasteners
on the base. For best results, ensure that the pad
is flat against the bottom surface and secured
tightly.
(Fig. 17)
CLEAN THE FLOOR
1 Press the extension wand release button and pull
the extension wand up.
(Refer to page 10,
Fig. 14-b)
2
Attach Dust-Away™ hard floor attachment onto
the end of the extension wand.
(Fig. 18)
3 Press the On/Off switch to the “I” position to
turn the suction motor on and begin cleaning
all hard surfaces.
IMPORTANT: Do not use to clean damp floors or
wet/sticky messes.
CARE FOR PADS
1
Wash the pads separately with warm water
either in the washing machine or by hand
using liquid detergent.
2
Do not use bleach or fabric softeners as they may
damage or leave a coating that will reduce the
cleaning performance of the pads.
3
Tumble dry low or line dry to extend the life of the
micro-fiber fabric.
REPLACE PADS
1
For best floor cleaning results, we recommend
replacing your micro-fiber pads every 3-4 months
following normal use.
2
You can find and purchase replacement
micro-fiber dusting pads and accessories
at
www.sharkclean.com
TO REPLACE THE MOTORIZED FLOOR BRUSH
FOR UPRIGHT CLEANING
1 Press the red release at the bottom of
the extension wand
and remove the
hard floor attachment.
2
Replace the canister back onto the motorized floor
brush and re-insert the handle with extension
wand back into the top of the vacuum body until
you hear these click into place.
When attaching the motorized floor brush, ensure
that the locking mechanism is fully locked in place
to ensure electrical connection has been made.
Fig. 17
IMPORTANT: Use only in
Portable
Lift-Away
®
mode.
NV355_NV356_NV356E_NV357_IB_110621_2.indd 12 11-06-21 3:40 PM
1
12