Shark KG-252437, Руководство оператора, Страница: 8 / 19

´ µ¶· ¸¹ º´ » µ · ¼ ½¾ ¼ ¿ À
v. 02/14
OPERA
T
OR’S MANU
AL
PRESSURE W
ASHER
Á
 ÃÄ Å ÆÇ
Attach the handle to the
frame of the pressure washer. Note :
It may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
STEP 2: Insert the carriage bolt
through the holes from the back of
the unit and attach a knob from the
front of the machine. Tighten Knobs
with by hand.
STEP 3: Attach the Gun & hose
hanger and insert nuts and wash-
ers from inside. Tighten nuts. (Hose
hanger position: see "COMPO-
NENT IDENTIFICATION")
STEP 6: Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 7: Connect the high pressure
hose to the discharge nipple.
STEP 5: Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
STEP 8: Connect garden hose to
the cold water source.
ASSEMBLY INSTRUCTIONS
STEP 9: Check inlets fi lters, re-
move debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Alignment
Holes
Handle
Frame
Assy.
Bolt
Knob
Gun &
Hose
Hanger
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Nut
Washer
STEP 4: Attach the high pressure
hose to the spray gun using tefl on
tape (not included) on hose threads.
È ÉÊ
ety
Latch
Spray
Gun
High
Pressure Hose
 ÃÄ Å Ë Ç
Attach wand to spray gun/
wand. Tighten both.
Wand
Spray
Gun