sharkclean.co.nz
sharkclean.com.au
MAINTAINING YOUR VACUUM
CHECKING FOR BLOCKAGES
Checking for Blockages in the Handheld Vacuum:
1.
Turn off vacuum.
2.
Remove the handheld vacuum from the wand.
3.
Check all intake openings to the dust cup and remove any
debris or blockage.
Checking for Blockages in the Wand:
1.
Turn off vacuum.
2.
Remove the handheld vacuum and floor nozzle.
3.
Check intake openings for blockages and debris.
4.
Clear away debris and blockages.
Checking for Blockages in the Floor Nozzle:
1.
Turn off vacuum.
2.
Detach the wand.
3.
Use the edge of a coin to open the three locks on the
bottom of the floor nozzle.
4.
Remove the cover and tilt back the neck of the floor
nozzle.
5.
Check the opening and remove any debris.
6.
Replace cover by firmly pressing down on all sides and
turning the locks clockwise.
FLOOR NOZZLE
MAINTENANCE
SELF-CLEANING BRUSHROLL
1.
Turn off the vacuum.
2.
Using a coin, turn locks counterclockwise to open, then lift off cover to access brushroll.
3.
Clear airway of blockages.
4.
Replace cover by sliding inserts into slots, then pressing down firmly on all sides before turning locks
clockwise to close, until they click securely into place.
FLOOR NOZZLE
If you run over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug. If some fibers remain wrapped around the brushroll after continued use,
carefully remove them.
