CHARGING THE CORDLESS SWEEPER
I,
Connect the charger plug to the charging jack or hole on the back of the
sweeper. Plug the the charging adapter into the wall outlet. (120V-,60Hz.) Use only
TechWorld Charger AD-092~UL, rated output DC9V,200mA. (Fig. 9)
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use,
they must be charged for a minimum of 16 hours.
3. Once the batteries are fully charged, the cordless sweeper will run for
approximately 35 to 45 minutes before recharging is required.
4. When recharging the unit, the “On/Off’ switch must be in the “OFF” position.
5. To recharge, repeat step #I above. Charging times will vary depending upon
the amount of usage between charging cycles.
6. The charging light indicator on the top of the sweeper will illuminate
to indicate that the sweeper is properly charging.
Figure 9
I
NOTE: Peak performance may only
be
realized after the unit has been
charged and discharged two (2) or three (3)
times.
I
IMPORTANT:
To maintain peak performance of your cordless
sweeper, it is recommended that the unit be fully
discharged, then completely re-charged at least once a
month.
CAUTION
l
Use only with the battery pack supplied with the unit.
l
Do not attempt to remove the battery pack from the unit to charge it.
l
Never attempt to throw the battery pack or unit into a fire or incinerate
it.
l
Do not attempt to remove or damage the battery casing.
l
Battery must be recycled or disposed of properly at the end of it’s
service life.
6