s h a r kc l e a n . e u
s h a r kc l e a n . e u
MAINTENANCE
To reinstall, place bottom of dust cup into pod and
then tilt it until it clicks into place.
Press the button on the bottom of the dust cup to
release debris into the trash.
To remove the dust cup from the Lift-Away® pod, slide
up both
Dust Cup Release
latches on the back of the
handle at the same time and pull out the dust cup.
To remove collected debris from
Mesh Screen
,
press top release button and lift handle to open.
IMPORTANT:
Unplug the power cord before performing any maintenance.
EMPTYING THE DUST CUP
CLEAN HEPA FILTER
EVERY YEAR
Press the
Cover Latch
above the
Filter Cover
,
then pull off the cover. Push the tab on the
front of the cover to detach the
HEPA Filter
.
To replace the HEPA filter, snap it back into
the pod, then slide-on the cover until it clicks
into place.
CLEAN PRE-MOTOR FILTERS
ONCE A MONTH
Remove
Dust Cup
, then lift out the
Filter
Frame
. Pull up the
Foam Filter
to remove it
from the filter frame. The
Felt Filter
is built
into the support frame.
To reinstall, insert the bottom of the dust cup
into the pod and tilt it until it clicks into place.
Regularly clean and replace the filters to keep your vacuum's suction power optimal.
To clean filters, rinse with cold water only. Allow all filters to air-dry for at least 24 hours before
reinstalling them to prevent liquid from being drawn into electric parts.
MAINTENANCE
CLEANING FILTERS
IMPORTANT:
DO NOT
use soap when cleaning the filters.
Foam Filter
Filter Frame
Cover Latch
HEPA Filter
Filter Cover
NOTE:
To order replacement parts and filters, visit
sharkaccessories.com
.
Replacement
Pre-Motor Foam &
Filter Support Kit
Replacement
HEPA Filter
The
Pre-Motor Filters
should be replaced every 2.5 years. The
HEPA Filter
should be replaced every 3 years.
REPLACING FILTERS
PRE-MOTOR FILTERS
HEPA FILTER
