Shark DG-2123, Инструкция по эксплуатации и каталог запасных частей, Страница: 6 / 34

sHarK dg • 97-720 • reV. 9/06
OPERA
TOR’S MANU
AL
PRESSURE
W
ASHER
6
STep 1: attach the handle to the
frame of the pressure washer. Note :
it may be necessary to move the
handle supports from side to side
in order to align the handle so it will
slide over the frame supports.
STep 2: insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. tighten
nuts.
STep 3: attach the spray gun/hose
storage handle and bracket to
handle. tighten nuts.
STep 4: attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STep 7:
release the coupler collar
and push the nozzle until the collar
clicks. pull the nozzle to make sure
it is seated properly.
STep 8:
connect the high pres-
sure hose to the discharge nipple.
push coupler collar forward until
secure.
STep 5: attach nozzle extension
to spray gun/wand. tighten both
by hand.
STep 6: pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
STep 9:
connect garden hose to
the cold water source.
aSSeMBly iNSTRUCTioNS
STep 10: check inlets filters, remove debris,
then connect the garden hose to pump water
inlet.
CAUTION: Do not run the pump without
water or pump damage will result.
alignment
holes
handle
frame
assy.
Carriage
Bolt
Nut
Studs
Nut
hose/Gun
Storage
Bracket
Safety
latch
Spray
Gun
high
pressure hose
Nozzle extension
Spray
Gun/Wand
Wand
Coupler
pressure
Nozzle
pressure
Nozzle
Wand
Coupler
Coupler
Collar
discharge
Nipple
high
pressure
hose
Cold
Water
Source
Garden
hose
pump
Water inlet
Garden
hose
Coupler
Collar
Bolts