Shark DE series, Руководство по эксплуатации, Страница: 6 / 20

96-720, 97-708, 97-709, 97-710 • REV. 8/04
OPERA
T
OR’S MANU
AL
PRESSURE W
ASHER
6
STEP 1: Attach the handle to the
frame of the pressure washer.
Note: It may be necessary to move
the handle supports from side to
side in order to align the handle so
it will slide over the frame supports. STEP 2: Insert the carriage bolt
through the holes from the outside
of the unit and attach a nut from
the inside of the machine. Tighten
nuts. STEP 3: Attach the spray gun/hose
storage handle, and bracket to
handle. Tighten nuts.
STEP 4: Attach the high pressure
hose to the spray gun using teflon
tape on hose threads.
STEP 7: Release the coupler col-
lar and push the nozzle until the
collar clicks. Pull the nozzle to
make sure it is seated properly. STEP 8: Connect the high pressure
hose to the pump discharge fitting.
Push coupler collar forward until
secure.
STEP 5: Attach nozzle extension
to spray gun/wand. Tighten both
by hand. STEP 6: Pull the spring-loaded col-
lar of the wand coupler back to in-
sert your choice of pressure nozzle.
STEP 9: Connect garden hose to
the cold water source.
ASSEMBLY INSTRUCTIONS
STEP 10: Connect the garden hose to
pump water inlet. Inspect inlets.
CAUTION: Do not run the pump with-
out water or pump damage will result.
Alignment
Holes
Handle
Frame
Assy.
Carriage
Bolt
Nut
Studs
Nut
Hose/Gun
Storage
Bracket
Safety
Latch
Spray
Gun
High Pressure
Hose
Nozzle
Extension
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Wand
Collar
Pump Discharge
Fitting
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
Bolts