Shark BR-304037, Инструкция по эксплуатации и каталог запасных частей

Страница: 14 / 36

Shark BR 97-723 • REV. 5/07
PRESS
u
RE
W
ASHER
Tr
oub
leshooting Guide
14
TRoUBlEShooTINg
pRoBlEM poSSIBlE CaUSE SolUTIoN
ENgINE opERaTES
foR 15 MIN. ThEN
STopS Not enough gas or engine oil Fill tank with gas. Check oil level.
Vapor lock developed by heat of
day Keep gas tank full to avoid vapor locking.
Obstruction in fuel filter Clean or replace fuel filter.
ENgINE laCkS poWER
Dirty air filter Replace air filter.
ENgINE falTERS
Choke is opened too soon Move choke to halfway position until en-
gine runs smoothly.
WaTER dRIppINg
fRoM UNdER pUMp Piston packing worn Call technical support.
O-Ring plunger retainer worn Call technical support.
Cracked piston Call technical support.
oIl dRIppINg Oil seal worn or damaged Call technical support.
WaTER lEakINg fRoM
pUMp pRoTECToR
Spray gun closed with machine
running 5 minutes or longer Open spray gun or turn off machine.
Excess water supply pressure Place a pressure regulator at end of 50’
garden hose.
No dETERgENT
Detergent suction tube not prop-
erly connected to machine Check connection.
Detergent is too thick Dilute detergent. For best results, use
Rhino detergent.
Detergent filter valve is at lowest
setting Set detergent filter valve to a higher set-
ting.
Filter on detergent suction tube is
clogged Run warm water through filter to remove
debris.
Damaged or clogged detergent
suction tube Remove obstruction or replace detergent
suction tube.
A high pressure nozzle is at-
tached. Replace with black detergent nozzle.
Discharge nozzle is obstructed Blow out or remove debris with fine needle.
gaRdEN hoSE
CoNNECTIoN lEakS Loose fittings Tighten fittings.
Missing/worn rubber washer Insert new washer.
SpRay WaNd lEakS
Spray wand not properly attached Slide the spray wand into the gun. Turn the
wand collar clockwise onto the spray gun
threads until tight.
Broken o-ring Call customer service and order an o-ring.
pUMp IS NoISy
Pump is sucking air Check that hoses and fittings are air tight.
Turn off machine and purge pump by
squeezing trigger gun until a steady flow of
water emerges through nozzle.