WARNING
Read and observe to prevent severe personal injury or property damage.
Page 2
Shark 808/1010 • Rev. 7/02
●
Check hoses, fittings, wand, trigger gun
and fuel connections daily for signs of
wear, cracks and looseness, and replace
as required.
●
Make sure all switches and controls are
in the OFF position prior to plugging in
electrical cord.
●
Do not stand in water while plugging and
unplugging electrical cord.
●
Use UL grounded type receptacles of
proper voltage and amperage rating at all
times.
●
Keep all electrical components on
machine dry.
●
Do not point wand or trigger gun at your-
self or at any person. Bodily injury may
result from water under high pressure.
●
Do not block or tie trigger gun in open
position.
●
Wear eye, ear, hand, foot, and skin pro-
tection at all times while operating pres-
sure washer.
●
Avoid contact with non-insulated areas of
pressure washer to prevent the possibil-
ity of severe burns.
●
Do not allow machine to run unattended.
●
Do not run machine indoors or in an
enclosed area, as exhaust fumes may be
hazardous to your health.
●
Do not operate machine in areas where
flammable vapors, (gasoline, solvents,
etc.) may be present, as this machine may
ignite the vapors.
●
Do not store flammable liquids (gasoline,
diesel fuel, solvents, etc.) near pressure
washer or in non-ventilated areas.
●
Use extreme caution when moving
pressure washer over rough or uneven
surfaces.
●
For permanent installation consult local
building codes for installation require-
ments. Licensed contractor may be
required.
●
Disconnect power supply prior to perform-
ing any maintenance.
●
Troubleshoot machine prior to using
reset buttons. See
Troubleshooting
Guide
.
●
Pressure washers produce a kickback. To
prevent personal injuries due to falls use
auxiliary safety equipment.
●
When applying detergents follow the
safety rules on the detergent label.
●
Use detergent from a covered D.O.T.
approved container.
●
Cleaning area should be provided with
adequate slopes and drainage. This will
reduce the possibility of a fall due to slip-
pery surface.
●
Unauthorized machine modification or use
of non-approved replacement parts may
cause personal injury and/or property
damage and will void the manufacturer
warranty.
●
This machine has been provided with
Warning and Instruction decals for the
safety of the operator. If these decals are
removed or become damaged they should
be replaced. Contact your dealer for
replacement decals.