Shaper Origin S01-NN, Руководство по эксплуатации продукта

Страница: 22 / 32

TM
20
Do not forcibly move the Z-Axis carriage up and
down. Doing so may cause damage to Origin’s
electronics.
Do not forcibly move the spindle mount from side
to side. Doing so may cause damage to Origin’s
electronics.
Cut at an appropriate depth per pass. Origin can
easily and consistently do multiple passes on your
design at increasing depths. Do not attempt to cut
deeper in one pass than Origin’s movement stage
or spindle can handle. If Origin sounds like it is
audibly struggling, reduce the depth of your cut,
change your material or router bit, or adjust spin-
dle speed. Visit support.shapertools.com for rec-
ommendations on how to cut various materials.
Cut at an appropriate feed rate. If Origin’s cor-
rection range is unable to keep up with your feed
rate, move Origin slower, reduce the depth of cut,
change your router bit, and/or adjust the spindle
speed. Visit support.shapertools.com for recom-
mendations on appropriate feed rates for various
materials.
Use an appropriate router bit for your material.
Different materials cut best with different types of
router bits. Cutting with the wrong type of router
bit can negatively impact cut quality. Do not cut
with dull or damaged router bits. Visit support.
shapertools.com for recommendations on router
bit types to use with various materials.
Safety & Care