STEP 1. PREPARING YOUR BLIND
Mark the intended position of your window
using the measurements indicated here.
You can opt to center a single blind opening on
your wall, or you can place two windows side
by side. If installing two windows, position them
about 6 inches apart.
Cut the window frame.
STEP 2. INSTALL THE EXTERIOR
SHIELD TRACKS
2A
- On each of the 8” sides, measure over 1- 3/4” at the
top and bottom corners. Be sure to mark all four spots.
2B -
Using the marks as a guide, position the first
exterior shield track along one side of the window
opening. Raise the channel about 1/8” above the top of
the window. Use 1 pan head screw to hold the exterior
track in place.
Repeat step 2B on the opposite side.
2C -
Make sure each track is aligned at the top and
bottom of the window opening. Use a total of 3 pan
head screws to fasten each track in place.
(Gun window instructions continue on the other side)
Screws & hardware included
for two window system:
[16] #8 x 1" Washer Head Screws
Use 3 screws per interior glass track.
[22] #8 x 3/4" Pan Head Screws
Use 3 screws per exterior track.
Use 5 screws per drip cap, evenly spaced.
[2] Rubber Window Shield Stops
[2] Interior Glass Panel
[2] Window Shield with Draw Cord
[2] Drip Cap
[4] Exterior Shield Tracks
[4] Interior Shield Tracks
[2] Speed Cinch®
Speed Cinch ®
Exterior Window Shield
with Draw Cord
Exterior Shield Track
Exterior Drip Cap
Interior Shield Track
#8 x1” Washer
Head Screws
Tools Needed:
Cordless Drill • Square Drive Bit • Tape Measure • Saw
Interior Glass Panel
Rubber Window
Shield Stop
STEP 3. INSTALL THE EXTERIOR SHIELD
Drop the exterior shield into place behind the exterior
shield tracks. The cord hole should be on the bottom
of the shield.
24-1/2" WIDE
8" HIGH
42" from floor to
bottom of window
